10 Rear Viewq Power Cooling FanPrevents the temperature of the recorder from rising. Donot block the ventilation openings.w AC Power Connector (AC IN)Connect the supplied power cable to this AC powerconnector.e Power Switch (POWER)This switch turns the power of the disk recorder on andoff.r Signal Ground Terminal (SIGNAL GND)t Mode Selection DIP switches (MODE)This 2-bit DIP switch is used for setting the terminal sys-tem. Refer to DIP Switch Setting for details.y Data Port (DATA)This port is for data communication with externaldevices.u 10Base-T/100Base-Tx Port (10/100BASE-T)This port is used to exchange control data with Ethernetvia an Ethernet Hub.i Copy Port (COPY 1)This port is used to connect an external hard disk toback up the data recorded on the hard disks.o Serial Data Port (SERIAL)For servicing purpose only.!0 Terminal/Control Port (TERMINAL/CONTROL)This port controls terminal inputs 1-8 and alarm outputs1-3. It is also used to connect component cameras withthe RS485 protocol feature.!1 VGA Output Port (MONITOR (VGA))When a VGA monitor is connected to this port, thesame image as supplied from the video output terminalis obtained.!2 Video Output Connector (VIDEO OUT)Spot live, split-screen, and playback pictures are outputfrom this BNC connector. All menu settings and screendisplay information are also output from this connector.!3 Video Input Connectors (VIDEO IN 1-8)System cameras or component cameras are connectedto these BNC connectors. A 75 Ω termination is madeunless the video output terminal is connected.!4 Audio Input Connectors (AUDIO IN 1-8)These are used for BNC standard jacks. Each of themaccept an unbalanced –10 dBV, 22 kΩ line input audiosignal supplied from an external device.!5 Audio Output Connector (AUDIO OUT)This is used for a BNC standard jack that supplies anunbalanced –10 dBV, 22 Ω line output audio signal toan external device.MODE DATA 10/100BASE-T COPY1 SERIAL MONITOR(VGA)TERMINAL/CONTROLAUDIO OUTVIDEO OUTAC INSIGNAL GNDPOWER 1122334455667788ONOFF!4!5e w!3!2!1!0oiuytq rVIDEO INAUDIO IN

operating instructions

Important Safety Instructions

Limitation of Liability

Precautions

Preface

Major Operating Controls & Their Functions

rear view

Installation

System Composition and Connections

Network System

Setup Procedures

turning the power off

Operation

camera control

Setup

search and playback

disk management

default settings

System Screen Explanations

Setup Menu Parameters and Initial Setup Values

Operation using the system controller

Troubleshooting

Specifications

I Table of Recording Length

Panasonic WJ-HD88 Operating Instructions Manual

WJ-HD88

Trademarks and Registered Trademarks

Installation of the WJ-HD88 Monitoring System Software

System Setup and Operations

Remote Monitoring Control

Disconnection of the Channel for Remote Monitoring

Control Playback Images

I System Control Panel

Recorder Configuration

Recorder Reboot ("Recorder Reboot")

Frame Playback ("FramePlay")

Monitoring System Configuration

Local Playback

Electro Map ("ElectroMap")

Sequential display

Remote Talk

Operation on the Multiscreen Selection Control Area

Operation of the Image Channel Selection Panel

Operation on the Recorder Information Area

Local Playback Starting

Local Playback File

Record Search ("Search File")

USB Equipment

Operation on USB Client

Alarm Center

Alarm Center Port Setup

Time Synchronization among Recorders

Starting of SetRecorderTime

Panasonic WJ-HD88 Operating Instructions Manual

Product

Learn More

Legal