Panasonic Viera TX-P50VT20BA Operating Instructions Manual

Contents

Panasonic Viera TX-P50VT20BA Operating Instructions Manual Manual pdf 111 page image

On screen messages●Frequently Asked Questions● FAQs, etc.111Message Meaning / ActionAll contents will be lost.Are you sure to delete this device?Once you unregister the USB HDD, all the recorded programme will be●erased.All tuning data will be erased “Shipping Condition” will erase all tuning data (p. 57).●Are you sure ? Confirm correct operation.●Are you sure you want to delete thistimer ?Press OK to delete timer.Press RETURN to return.Confirm correct operation.●Bad signalThe signal is weak. Check the aerial is plugged in properly. It may●be necessary to have an aerial installer check the signal and aerialalignment.Reset channels. (p. 46 and p. 47)●Cannot register another device becausethe list is full. Up to 8 USB HDDs can be registered with this TV.●Child Lock is active!Press OK to enter PIN.The selected channel is locked in Child Lock (p. 60). You must enter the●PIN number before the channel will be displayed.Faulty dishThe satellite cable might be short-circuited or there might be connection●problems of the cable. Check the cable and connection and then turn theTV Off with the Mains power On / Off switch, and turn it On again.If the message still persists, it may be necessary to have a dish installer●check the dish and cable.Feature not available.It is not possible to record from COMPONENT or HDMI. Connect the●recorder to the TV using a fully wired SCART cable for recording from theTV tuner.Confirm Q-Link or VIERA Link settings (p. 92 - 95).●Feature not available.Press OK to view how it works.The selected feature on VIERA TOOLS is not available. Press the OK●button to view the demonstration to explain how to use it.Found new software version ∗∗∗.Press OK to start update (may take40 mins) or Press EXIT to ignoreand you can update when TV is in standbyThere is a new software available.●Invalid operation - Please check settingsand connections. Check the Q-Link or VIERA Link connection and setting (p. 92 - 95).●Invalid system time. Please exit ! Cannot get the time information and cannot edit Timer Programming●screen. Check the connection of the RF cable.Invalid system time, Timer Programmingwill not work.Please press TV button on remote controland check time display on BannerCannot get the time information. If there is no time displayed on the●Information banner, check the connection of the RF cable.Max. number of timers already set ! The maximum number of timer programming events is 15.●New channels found!Press OK to update channel list.Press EXIT to ignore.There may be new channels available.●This message will appear each time a change is made by the●broadcasters. This message can be deactivated by setting “New ChannelMessage” to Off in “DVB Tuning Menu”.Selecting OK will perform “Update Channel List”.On screen messages