Panasonic Viera TX-P50VT20BA Operating Instructions Manual

Contents

Panasonic Viera TX-P50VT20BA Operating Instructions Manual Manual pdf 112 page image

112On screen messagesMessage Meaning / ActionNo channel found.Please check aerial or local signalavailability.Press OK to start Auto Setup.Follow the on screen instructions.●Please also refer to p. 107.●If channels are still not found, consult your local Panasonic dealer.●No module inserted Check the CI module is inserted completely (p. 64).●No recording - Already recording The equipment may already be recording.●No recording - Check media The tape or disc may be “write protected”, full, missing or damaged.●No recording - Playing The equipment may be playing the tape or disc.●No recording - Unknown reason The recording may not be performed. Check the equipment.●No service The broadcaster has stopped the service. Check the channel in the TV●Guide. (p. 20)No signal The TV cannot detect the signal. Check the connection of the RF cable.●Overcurrent error on USB deviceoccurred.Please remove the USB device, andswitch off the TV by mains power switch.The connected USB device might cause overcurrent error. Follow the on●screen instructions.Check if foreign objects are inside the USB port.●PIN incorrect! The PIN number you entered is wrong.●Please check settings and connectionson HDMI devices. Communication error in VIERA Link function (p. 95).●Please enter a frequency between10700 and 12750 MHz.The frequency you entered is out of range. Consult the received satelite●broadcasting company. (p. 54)Please wait. A function is in progress.●Recording this channel now The recorder is recording the programme from its own tuner. You can turn●the TV off and leave the equipment recording in the normal way.Reset to Factory Shipping ConditionCompleted.Please switch off TV.“Auto Setup” will automatically start when Mains power On / Off switch is●next turned On. (p. 12)Sending Preset Data Q-Link or VIERA Link channel download is in progress.●Software successfully updated.Press EXIT to continue. The software updating is finished.●Software update failed. Please try againlater.Press EXIT to continue.Perform “System Update Search Now” in System Update (p. 65).●If this is still unsuccessful, there may not be any new software available.The device is not directly connected tothe TV.The device may not work correctly.Please do not connect the device via a USB HUB.●This timer will not follow the TV Guideinformation.Press OK to continue, RETURN to restoreoriginal timer.If you edit the start time or end time of Guide link programming by more●than 10 minutes, it will no longer be performed as Guide link programming.The programming will be performed according to the time setting.