Panasonic Viera TX-P50VT20BA Operating Instructions Manual

Contents

Panasonic Viera TX-P50VT20BA Operating Instructions Manual Manual pdf 9 page image

Identifying Controls●Quick StartGuideFTVAVCommon Interface21HDMI 4AV 3VLR9Auto power standby function■ The TV will automatically go to Standby mode in the following conditions:● no signal is received and no operation is performed for 30 minutes in Analogue TV mode•“Off Timer” is active in the Setup Menu (p. 19)•no operation is performed for the period selected in “Auto Standby” (p. 42)•This function does not affect the recording of Timer Programming, Direct TV Recording and One Touch●Recording.Using the On Screen DisplaysMany features available on this TV can be accessed via the On Screen Display menu.How to use remote control■ MENU Open the main menu EXIT Exit the menu system and return to thenormal viewing screenMove the cursor / select the menu item Move the cursor / adjust levels / select froma range of optionsAccess the menu / store settings afteradjustments have been made or optionshave been setBACK/RETURN Return to the previous menuON SCREEN HELP Instructions box - Operation guide■Example (Owner ID):EXITRETURNPIN entry0 9Please enter new PINPINOwner ID* * * *Operation guide will help you.TVSD Card slot (p. 74)CI slot (p. 64)Infrared transmitter for 3D EyewearDo not place any objects between the●transmitter and 3D Eyewear.HDMI4 terminal (p. 101)AV3 terminals (p. 101)Headphones jack (p. 101)Remote control signal receiverDo not place any objects between the TV remote control signal●receiver and remote control.Function selectVolume / Contrast / Brightness / Colour / Sharpness /●Tint (NTSC signal) / Bass (“Music” or “Speech” mode in theSound Menu) / Treble (“Music” or “Speech” mode in theSound Menu) / Balance / Auto Setup (p. 46 and p. 47)USB 1 / 2 ports (p. 13, 70, 74 and p. 83)Power and Timer LEDRed● : StandbyGreen: OnOrange: Timer Programming OnOrange (flash): Recording of Timer Programming,Direct TV Recording orOne Touch Recordingis in progressRed withorange flash: Standby with Timer ProgrammingOn, Direct TV Recording orOne Touch RecordingThe LED blinks when the TV receives a command●from the remote control.Changes the input modeC.A.T.S. (Contrast Automatic Tracking System) sensorSenses brightness to adjust picture quality when “C.A.T.S.”●in the Picture Menu is set to “On” (p. 38)Adjusting the panel to your desired angleDo not place any objects within the full rotation range.●10°10°(View from the top)Mains power On / Off switchUse to switch mains power On / Off.●If the TV was switched off whilst in Standbymode, using the Mains Power On / Offswitch, then it will be in Standby mode whenswitched back on using the same switch.For changing TV channel up or down.When a function is selected by the F button, press to increase ordecrease the setting of the selected function.When in Standby mode, press either button for about 1 second toswitch the TV On.