Panasonic Viera TC-65PST34 Owner's Manual

Also see for Viera TC-65PST34: Owner's manual

Panasonic Viera TC-65PST34 Owner's Manual Manual pdf 39 page image

39AdvancedUsing Network servicesNetwork settingsThis is a setting for connecting to a broadband environment.■Press to exit froma menu screen■Press to go back tothe previous screenDisplay the menuSelect “Network settings”Menu Setup 1/2ANT/Cable setupInput labelsAnti image retentionNetwork settingsChannel surf mode3D settingsLanguageClockAllselectSelect the settings and set selectadjustMenu Network settingsNetwork cameras listSoftware updateMac addressConnection testNetwork connectionWireless networkIP address/DNS settingsNetwork linkWireless (WiFi)00-0b-97-7c-65-e9Connection testCheck that the Network settings are as shown below, and then start “Connection test”.Select “Connection test” and press OK(It takes a while to cancel the test.)Displayed Connection test screenConnection testCheck Ethernet cable connectionValidate IP addressCheck for IP address duplicationCheck connection to the InternetCheck communication with VIERA Connect server.Test in progress...Complete Connection testSuccess -->Completion screen is displayed.Error-->Follow the directions on screen to complete the setting.If you perform the Proxy settings, check the Proxy addressand the Proxy port number.Network connectionSelect Network type (Ethernet cable/Wireless (WiFi))Wireless network (Confirm Current settings and status)This setting is performed only when “Wireless (WiFi)” is selected in “Network connection” above.■Displayed “Current settings and status” screen (If connected with Wireless LAN Adapter)You can confirm the AP connection status.(SSID/Wireless type/Security type/Encryption type/Connection status /Signal strength)Press “Wireless network”Wireless networkSSID :Wireless type :Security type:Encryption type :Connection status :Signal strength :Connect using these settings?Yes No(example)selectOKWhen you change “Wireless network” -->Press “No”See “Sets / Changes wireless network setting” on p. 40and follow the directions on screen to complete thesetting.You need to be “Connected” to use network devices.Please set Access point settings to “Connected”.