Panasonic VL-VN1700 Installation Manual

Also see for VL-VN1700: Operating manual

Contents

Panasonic VL-VN1700 Installation Manual Manual pdf 45 page image

• Port: Enter the TCP Port for the SNTP Server.Daylight Saving• Select whether to enable or disable summer time (daylight saving time).UserOn this screen, you can specify the settings for users and extensions for the Control Box.When you have finished specifying the settings, click Next to continue.Number of Users• User: specify the number of users.Users Information Setting• WebMC Language: Select the language for the user portal site from the drop-down list.LANOn this screen, you can specify the settings for the LAN the Control Box is on.The IP addresses for the Control Box, DNS server, and DSP cards can be assigned automatically through aDHCP server or entered manually.Notice• If an external DHCP server is in use, it must be able to use the "client identifier" option specified byRFC 2131.• If an external DHCP server is in use, the Control Box DHCP Server feature must be disabled.• The Control Box will not start properly if IP addresses cannot be assigned automatically by the DHCPserver when the Control Box has been set to obtain IP addresses automatically. In this case, youneed to consult your network administrator because the DHCP server in your network may not berunning or a network failure may have occurred. If the DHCP server is not available, enter IPaddresses manually, then restart the Control Box. If the Control Box cannot be accessed over thenetwork, connect the PC directly to the Control Box with an Ethernet cable and access WebMaintenance Console using a direct connection.For details about connecting the PC directly to the Control Box, refer to "Direct Connection" in "4.2 PCConnection".• The appropriate values for these settings depend on your network configuration. For details, consultyour network administrator.NoteIf the IP addresses are changed from their default values, a notice about restarting the Control Box isdisplayed at the end of Quick Setup Wizard. Click OK to restart the Control Box. After the Control Boxrestarts, start Web Maintenance Console again (refer to "Connecting to Web Maintenance Console" in"4.3 Starting Web Maintenance Console").When you have finished specifying the settings, click Next to continue.IP Address for main unit1. Select the method for setting the IP address information.• Obtain an IP address automatically• Use the following IP address2. If you selected Use the following IP address, specify the following settings.• IP Address: Enter the IP address for the Control Box.4.4.1 Quick Setup WizardInstallation Manual 45