Panasonic VL-SDM100BX Operating Instructions Manual

Panasonic VL-SDM100BX Operating Instructions Manual Manual pdf 15 page image

Programming function settingsYou can change the function settings to suit your needs.How to change the function settings1 Press MMENUN, then select the “ALL SETTINGS” by pressing MFN or MEN.2 Press M N (Monitor button) (“OK”), then select the desired item by pressing MDN or MCN.3 Press M N (Monitor button) (“OK”).4 Press MDN or MCN to select the desired function, then press M N (Monitor button) (“OK”).R This step may not be necessary depending on the feature being programmed.5 Press MDN or MCN to select the desired setting, then press M N (Monitor button) (“OK”).6 To finish the operation, press MMENUN 2 times.Note:R When no operation is performed for about 60 seconds during settings, the setting function quits.Function listIn the following list, < > indicates the default settings.Item Function SettingSTART-UPSETTINGSPREVENTMOTTLED COLOR<POWER FREQUENCY (50Hz)> / POWER FREQUENCY(60Hz)R To prevent mottled or uneven color from beingdisplayed, set the power frequency to match the area inwhich you use the unit.SELECTLANGUAGE< ENGLISH > / FRANÇAIS / ESPAÑOL /DISPLAYSETTINGSWIDE/ZOOMSETTINGS<WIDE MODE> / ZOOM MODER Select how images are initially displayed: Wide or Zoom.CONTRAST When it is difficult to see the monitor display, you canadjust the display contrast. 5 levels are available.OPERATIONASSISTANCE<YES> / NOR Select NO if you do not want the operation assistance(page 11) to be displayed when viewing WirelessCamera images.BATTERY SAVEMODE –<OFF> / ONR Select ON to lengthen the time that the batteries can beused for. However, by selecting ON, the time it takes todisplay images when monitoring may increase.RESET SETTINGS–YES / NOR If YES is selected, the Monitor settings are reset.– A reset cannot be performed when the WirelessCamera is out of range. Only perform a reset whenthe Wireless Camera is within signal range.15How to use