Tuning Channels31 AdvancedDisplay a message New Channel MessageSelects whether to give a message when new Digital TV channels are found. (Off / On)New channels found!Press OK to update channel list.Press EXIT to ignore.Set Digital TV channel manually Digital TV Manual TuningSet Analogue TV channel manually Analogue TV Manual TuningManual TuningSet Analogue TV channel manually after Analogue TV Auto Tuning.If a VCR is connected only with the RF cable, select channel position “0”.1 BBC1CH33Analogue TV Manual TuningManual Tuning 0 75CH33Select a channel position Select a channel Search and storestoresearch●Update channels automatically Update Channel ListYou can add new channels, delete duplicated channels, update channel name and position automatically toChannel List.Digital TV Update Channel ListRF Ch Type QualityDigital TV: 0SearchingAnalogue Scan 21 68Scan CH 6 69This will take about 3 minutes.Channel NameThe Digital TV Channel List is updated with the current settingssaved as they are.●Normally use “Digital TV Auto Tuning” or “Update Channel List” to update Digital TV channels on your channellist.If tuning has not been done completely or for adjusting the direction of the aerial, use this function.Digital TV Manual TuningAnalogue Scan 21 68Physical ChannelNo. Type NewDigital TV: 0Signal Strength 0 10Signal Quality 0 10MHz562.00[CH32]Channel Nameselect physical channelsearchadjust frequency (set where the level of“Signal Quality” becomes the maximum)All channels found will be added to the Digital TV Channel List.●Check Digital TV signal Digital TV Signal ConditionSelects a channel and checks the Digital TV signal condition.To change the channel●A good Signal Strength is not an indication of suitable signal for Digital TVreception. Please use the Signal Quality indicator as follows:Signal Quality:Green bar GoodYellow bar PoorRed bar Bad (Check the aerial)●●●Digital TV Signal ConditionChannel Name 101 DZFinfokanalNetwork Name RiksTVRF Parameter [CH32] 562.00MHzSignal QualitySignal Strength0 2 4 6 8 10