104LSQT1150With a computer (VDR-D310/VDR-D230)≥ When data not supported by this unit has beenrecorded on a computer, it will not berecognized by this unit.1 Double click the icon in tasktray.Hardware disconnect dialog appears.≥ Depending on your computer’s settings, thisicon may not be displayed.2 Select [USB Mass StorageDevice] and click [Stop].3 Verify [MATSHITA DVD-RAMLMXK1987 USB Device] or[MATSHITA DVD Cam USBDevice] is selected and click[OK].Click [Close], and you can safely disconnect thecable.≥ If you disconnect the USB cable while theaccess lamp is on or while appears on theLCD monitor, it may damage the data.To verify the unit is correctly recognized by thecomputer, select the unit’s mode, connect theunit to the computer via the USB cable and thenfollow the steps below.≥ With some computers including those made byNEC, the Device Manager may not bedisplayed if a mode that places restrictions onthe functions has been established. Consultthe manufacturer or follow the steps in yourcomputer’s operating instructions to establish amode in which all the functions can be used,then proceed with operation.1 Select [start] # ([Settings] #)[Control Panel] # ([Performanceand Maintenance] #) [System].2 Click the [Hardware] tab, thenclick [Device Manager].3 Verify the following items aredisplayed.∫ If the driver has been recognizedproperlyWhen using a disc:Windows XP:≥ [MATSHITA DVD-RAM LMXK1987 USBDevice] is displayed at [DVD/CD-ROMdrives].≥ [USB Mass Storage Device] is displayed at[Universal Serial Bus controllers].Windows 2000 Professional:≥ [MATSHITA DVD-RAM LMXK1987 USBDevice] is displayed at [DVD/CD-ROMdrives].≥ [MATSHITA DVD-RAM LMXK1987 USBDevice] is displayed at [Disc drives].≥ [USB Mass Storage Device] is displayed at[Universal Serial Bus controllers].To disconnect USB cablesafelyVerifying the unit iscorrectly recognized by thecomputerLSQT1150.book 104 ページ ２００７年１月１９日 金曜日 午前９時２７分
