Panasonic UF-580 Service Manual

Also see for Facsimile UF-590: Technical guide Software guide Operating instructions Service manual

411. Printer Error Code TableErrorCode Description of Problems Cause00 No problem detected.11 Timing Sensor did not turn ON within acertain period of time.(Original Cassette Feeder)1. Recording Paper misfeeding, Paper FeedRoller defective.2. Drive Clutch defective.3. Timing Sensor defective.12 Timing Sensor did not turn ON within acertain period of time.(250 sheet Optional Cassette Feeder)1. Recording Paper misfeeding, Paper FeedRoller defective.2. Drive Clutch defective.3. Timing Sensor defective.14 Timing Sensor did not turn OFF within acertain period of time.1. Recording Paper Jam.2. Timing Sensor defective.3. Incorrect paper size setting.15 Paper Exit Sensor did not turn ON within acertain period of time.1. Recording Paper Jam.2. Paper Exit Sensor defective.16 Paper Exit Sensor did not turn OFF within acertain period of time.1. Recording Paper Jam.2. Paper Exit Sensor defective.17 Timing Sensor detected paper whileinitializing the unit.1. Recording Paper jammed in the unit.2. Timing Sensor defective.18 Paper Exit Sensor detected paper whileinitializing the unit.1. Recording Paper jammed in the unit.2. Paper Exit Sensor defective.22 The temperature of the Fuser Rollerremained low even after the circuit wasactivated.1. Fuser Unit defective.2. SC PCB defective.3. Power Supply Unit defective.23 Abnormally high Fuser Roller temperatureafter the circuit was de-activated.1. Fuser Unit defective.2. SC PCB defective.3. Power Supply Unit defective.24 The temperature of the Fuser Roller was notcontrolled within a certain margin.1. Fuser Unit defective.2. SC PCB defective.3. Power Supply Unit defective.25 Thermistor open.(See Note)1. Thermistor defective (Fuser Unit).2. SC PCB defective.26 Thermistor detected temperature over 392°F(200°C).(See Note)1. Thermistor defective (Fuser Unit).2. SC PCB defective.3. Power Supply Unit defective.31 The Tetragon Motor did not reach a constantspeed of 8,898 rpm (400dpi)/13,347 rpm(600dpi) within a specified period of time.1. LSU defective.32 The Tetragon Motor did not maintain aconstant speed of 8,898 rpm (400dpi)/13,347rpm (600dpi).1. LSU defective.36 HSYNC signal abnormal. 1. LSU defective.2. SC PCB defective.54 A/D Converter error. 1. SC PCB defective.61 Unit detected “No Toner Cartridge”. 1. Toner Cartridge not installed.2. Toner Sensor defective.63 Unit detected “Printer Cover Open”. 1. Printer Cover is not closed.2. ILS PCB defective.