Panasonic UF-580 Service Manual

Also see for Facsimile UF-590: Technical guide Software guide Operating instructions Service manual

28Function Parameter TableNo. Parameter Selections Function000 MON/TEL DIAL 1 = Monitor2 = TEL/DIALSelects whether the machine starts to TXautomatically during On-Hook dialing.Monitor : Start to TX after pressing STARTTEL/DIAL : Start to TX automatically001 ALARM STATUS 1 = OFF2 = Timer (6 sec.)3 = ConstantSelects the No Paper or No Toner alarm status.OFF : Alarm is disabled.Timer : Alarm will shut off after 6 seconds.Constant : Alarm will not stop until "STOP" ispressed or the error is cleared/corrected.002 STOP COMM.JRNL1 = Off2 = OnSelects whether the machine prompts to print theCOMM. Journal when the printout condition is set toINC and STOP is pressed during communication.003 CONTINUOUSPOLL1 = Off2 = Stn (Tx only)Selects whether the Continuous Polling feature isenabled.Stn:Place the document(s) on the ADF then press theProgram Key [P4] to store or add the document(s)into a polled file. (See Note 4)004 NUMERIC IDSET1 = Off (will not accept)2 = On (accepts)Selects whether the machine accepts and allows toset or change the Numeric ID.005 Not Used006 ID DISPLAY 1 = Number (Numeric ID)2 = Chara (Character ID)Selects the priority of displaying the ID.007 JNL COLUMN 1 = Preset station name2 = Received IDSelects the contents of the ID to display on theJournal.008 MONITOR 1 = Off2 = OnSelects whether the Monitor is ON/OFF formonitoring fax signals.(FOR SERVICE USE ONLY)009 DC LOOP 1 = Off (Normal)2 = On (Off Hook)Selects a false Off Hook state for back to backcommunication test.010 TX LEVEL 00 = 0 dBm~15 = -15 dBmSelects the TX signal output level, 0 to -15 dBm in 1dBm steps. (Refer to Chapter 4.3)011 RX LEVEL 1 = -43 dBm2 = -38 dBm3 = -33 dBm4 = -48 dBmSelects the receiving sensitivity of -33/-38/-43/-48dBm.012 DTMF LEVEL 00 = 0 dBm~15 = -15 dBmSelects the DTMF output level, 0 to -15 dBm in 1dBm steps.013 G3 RX EQL 1 = 0 dB2 = 4 dB3 = 8 dB4 = 12 dBSelects the cable equalizer for G3 reception mode,0dB, 4dB, 8dB or 12dB.014 G3 TX EQL 1 = 0 dB2 = 4 dB3 = 8 dB4 = 12 dBSelects the cable equalizer for G3 transmissionmode, 0dB, 4dB, 8dB or 12dB.