Panasonic UB-5325 Installation Manual

Also see for UB-5325: Operating instructions

Contents

Panasonic UB-5325 Installation Manual Manual pdf 19 page image

19EnglishOptional Wall-mounting Kit (KX-B063)Before attempting installation of this wall-mounting kit, we strongly recommend consulting with the building manager,engineer, or architect. The installer needs to know the type of construction used for the wall intended for thisinstallation and the location of wall studs. Selection of hardware is critical for safe wall-mounting, and depends on thenature of wall construction. Installation should not occur until this consultation takes place.• Do not attach the electronic board to mortared walls. Accidental electric leakage from the wall-mountingfixture bolts to metal laths or wire laths can cause heat, smoke or a fire.1. Tools required:A minimum of eight (8) pieces of appropriate wall-support hardware (molley, toggle, etc.)NOTE: THIS HARDWARE MUST BE LOCALLY PROCURED, IT IS NOT INCLUDED IN THE KIT.Drill (and drill bit of correct size) for hardware installationScrew driver (Both phillips (+) and slotted (–) will be required.)Tape measureTape or thumb-tacks (2 pcs)Bubble type level2. Pre-requisites1. Before installation, make sure that the wall intended for installation is capable of supporting flush-mounted.UB-5325 is 180 kgf (397 lbs.).UB-5825 is 195 kgf (430 lbs.).2. The position of the intended installation is of adequate size for the selected Panaboard.UB-5325 is 1,516 mm (H) × 1,550 mm (W) [5' (H) × 5' 2" (W)].UB-5825 is 1,516 mm (H) × 1,912 mm (W) [5' (H) × 6' 3" (W)].3. An outlet is within 3 m (9’ 10 1 /8" ), and not located behind the Panaboard.■ AccessoriesThe package box for the optional wall-mounting kit includes the parts noted below; please confirm that all parts arepresent before beginning installation. Eight screws for mounting the fixtures on the wall are not provided. Pleasepurchase the appropriate wall-mounting hardware (sold in stores). Refer to page 21.*These are used for other models.No. Part name Illustration Q’ty No. Part name Illustration Q’tyWall-mountingfixture L 2 Screw(Not use*)M4 x 16 mm ( 20/32”)4Wall-mountingfixture R 2Wall-mountingtemplate(Not use*)1Wing bolt M5 x 12 mm (15/32”)(For mounting of theelectronic board)2Use the wall-mounting templateprovided withUB-5325 / UB-5825.Caution

/ 22

Related manuals for Panasonic UB-5325