Panasonic UB-5325 Installation Manual

Also see for UB-5325: Operating instructions

Contents

Panasonic UB-5325 Installation Manual Manual pdf 13 page image

13EnglishElectronic Board Operations CheckAfter assembling the electronic board, perform the procedures presented in the following table to make sure itfunctions properly.*1 Contact the store or dealer from which the unit was purchased.Step Points to CheckSymptom Solutions1 Turn on the power switch. “ ” flashes after “ ” lights up. (Normal operation)(If not) Check power cord. (Seestep 15 on page 11.)2 Open the printer door and attachthe accessory thermal transfer film,then close the printer door.• Installing Thermal Transfer Filmprocedure (refer to the OperatingInstructions on page 10)“ ” flashes. (Normal operation)(If not) Check thermal transferfilm.3 Open the paper cover and insertordinary A4 (Letter) test paper, thenclose the paper cover.• Loading Copy Paper procedure(refer to the OperatingInstructions on page 11)“ ” lights up. (Normal operation)(If not) Check copy paper.4 Open the printer door. “ ” flashes. (Normal operation)(If not) * 15 Close the printer door. “ ” lights up. (Normal operation)(If not) * 16 Press . Screen is fed. (Normal operation)The screen film surface is not fedsmoothly. * 1There are strange noises.7 Use the accessory marker todraw a large filling theentire copyable area of thescreen film surface.• Copyable area (refer to theOperating Instructions onpage 7)Press twice.Press .“ ” lights up and three copies aremade.(Normal operation)Three copies are not made. * 1The entire readable area is not printed.There are strange noises or paperjams during the copying process.Multiple sheets of paper are fedthrough at the same time.8 Press to move the screenfilm surface. Write letters, etc.with the marker.Press once.Press .The Contrast/Remaining Film indicatorlight is turned on and one copy is made.(Normal operation)The Contrast/Remaining Film indicatorlight is not turned on. * 1The image is not copied properly.There are strange markings on thecopy sheet (e.g., stripes or lines).9 Press once. The Contrast/Remaining Film indicatorlight is turned off.(Normal operation)(If not) * 110 Press . Two screens are copied properly. (Normal operation)(If not) * 1