Panasonic TY-TP65P10S Operating Instructions Manual

Also see for TY-TP65P10S: Operating instructions Operating instructions Service manual

Panasonic TY-TP65P10S Operating Instructions Manual Manual pdf 16 page image

16Connections and Plug-InsActivate power to the plasma display and computer.Check that the computer’s OS starts up.Connect the touch panel and computer with the USB cable.When connected, Plug & Play starts. (p. 17)Plasma display(To connect to your computer,see the instruction manual ofthe plasma display.)Attach the USB cable anchor. Attach the USB cable anchor to the USB cable. Align the screw holes on the USB cable anchorwith the holes on the touch panel. Tighten mounting screw A by hand.123Caution• Connect the USB cable only after installing the Driver software.• Before connecting the USB cable, attach the ferrite core to the cable. (See below.)• Check that the USB power supply of your computer is a max. 500 mA.Caution• Obstructing the infrared transmissive part with your fingers, for instance, or touching the screen whileconnecting the USB cable might be detected as defective elements. If used as is, the response of the touchpanel might slow down.In such case, with the computer started up, disconnect the USB cable and reconnect it.• To use a USB hub, power must be supplied to the hub. For details, see the instruction manual of your USB hub.ComputerUSB cableUSB portTouch panel Connect to the USB porton your computer.(Rear view)Ferrite coreMounting screw AUSB cableUSB cable anchor1. Pull the tabs onthe ferrite core toopen the core.2. Run the USB cable into aloop at a point about 20cm from the touch paneland fit the crossoverpoint of the loop into theferrite core.2 locationsApprox. 20 cm3. Close the ferritecore.