- 68 -Update:Performs the update of the GUIDE Plus+ schedule for the GUIDEPlus+ system (only available in some countries).Postcode:Sets your postcode to receive local information in the GUIDE Plus+system (only available in some countries).System Information:Displays the system information of the GUIDE Plus+ system (onlyavailable in some countries).● DVB-T and Analogue channels are displayed on the same TV Guidescreen. D and A may be displayed to distinguish DVB-T and Analoguechannels. There will be no programme listings for Analogue channels.Timer ProgrammingThis function allows you to select programmes that you want to be remindedto watch or record to the USB HDD.1. Select the forthcoming programme with / / / and press OK toaccess.2. Select USB HDD Rec. / Reminder with / and press OK to set.● To check / change / cancel a timer eventRecording > Timer Programming > Editing Timer Programming● LED will turn to orange in Standby mode if Timer Programming is set.● To return to TV GuideBACK/RETURN● If you select the current programme, a confirmation screen askingwhether you want to watch or record the programme appears. SelectTimer Programming with / and press OK to set USB HDD Rec. torecord from the time you finish the timer event setting.● Depending on the country you select, you can set Signal SupportedRecording (see below).= Note =● Not valid in Analogue● Timer Programming only works reliably if correct time information isreceived via the signal from the broadcaster or service provider.● No other channels can be selected while the recording of TimerProgramming is in progress.● When recording programmes to the USB HDD, be sure to format the USBHDD and enable it to record in USB Device Setup.Recording > USB HDD setup
