Panasonic TX-28DK1 Operating Instructions Manual

Panasonic TX-28DK1 Operating Instructions Manual Manual pdf 30 page image

STRTV/AVSET UP30Your new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a Scart connection ispreferable if the VCR is so equipped.However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound from your VCRon programme position ‘0’ of the TV. It will be necessary to either adjust the RF channel of your VCR (some VCR’s allow adjustment oftheir RF channel via their remote control unit) or to adjust the tuning of the TV’s programme position ‘0’ or both until it receives the RFoutput channel of your VCR.It is intended that this advice is used in conjunction with the instruction books for your additional equipment.Use the AV1 Scart terminal for a VCR.Use the AV2S Scart terminal for an S--Video VCR.Use the AV2S Scart terminal for a Q--Link, NEXTVIEWLINK or compatible VCR.To tune your TV to the VCRSwitch on the VCR, insert and play apre--recorded tape with known contentOpen the Setup menuMove to Tuning menuAccess Tuning menuMove to Manual tuningAccess Manual tuningSelect programme position ‘0’ VCRStart searching for the VCR playbackof the known content tapeWhen the VCR playback is found,press STR to storePress the TV/AV button to exitSee below for installation of VCR and SatelliteReceiverNotes :D If picture patterning occurs on programme position ‘0’ itmay be necessary to adjust the RF output channel ofthe VCR, refer to the VCR instruction book.D If a Satellite Receiver and a VCR are going to be usedwith RF cable connections it is important to avoid bothunits being set on the same channel.Refer to the Satellite Receiver and VCR instructionbooks for precise tuning information.VCR AND SATELLITE RECEIVER INSTALLATIONSetup menuTeletext FASTEXTOff timer OffTuning menu AccessTV/AVSelectAccessExitManual tuning21 68VCRCH32Return --Programmedown/upSearchdown/upExitTV/AVVCR’STR’ Button Store