Panasonic TX-28DK1 Operating Instructions Manual

Panasonic TX-28DK1 Operating Instructions Manual Manual pdf 3 page image

Example 2.Example 1.3D This TV set is designed to operate on 220 -- 240V, 50Hz A.C.D To prevent damage which might result in electric shock or fire,do not expose this TV set to rain or excessive moisture.This TV must not be exposed to dripping or splashing waterand objects filled with liquid, such as vases, must not beplaced on top of or above the TV.D WARNING : HIGH VOLTAGE !!!Do not remove the rear cover as live parts are accessible whenit is removed. There are no user serviceable parts inside.D Avoid exposing the TV set to direct sunlight and other sourcesof heat.D The On/Off switch on this model does not fully disconnect theTV from the mains supply. Remove the mains plug from thewall socket when the TV set is not used for a prolonged periodof time.D CABINET AND PICTURE TUBE CARERemove the mains plug from the wall socket. The cabinet andpicture tube can be cleaned with a soft cloth moistened withmild detergent and water. Do not use solutions containingbenzol or petroleum. TV sets can produce static electricity,care must be taken whenever touching the TV screen.D Adequate ventilation is essential to prevent failure of electricalcomponents, we recommend that a gap of at least 5cm is leftall around this television receiver even when it is placed insidea cabinet or between shelves.FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLYThis appliance is supplied with a fitted three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug. If thefuse is replaced then the replacement fuse must be 5 amp rated and should be approved by ASTA or BSI to BS1362.Check for the ASTA mark ASA or the BSI mark on the body of the fuse.If the fitted plug has a removable fuse cover you must ensure that it is refitted when the fuse isreplaced. If you lose the fuse cover the plug must not be used until a replacement cover isobtained. Replacement fuse covers can be purchased through your local Panasonic dealer.The plug fitted to this appliance incorporates a mains filter circuit. If this is removed orreplaced with a non--filtered plug this television will no longer meet the Europeanstandards for Electromagnetic Compatibility (EMC). If the fitted plug is unsuitable forthe socket outlet in your home an appropriate adapter should be used.Nonetheless, if the fitted plug is replaced, the fuse should be taken out and the cut--offplug disposed of safely. There is danger of severe electrical shock if the cut off plug isinserted into any 13 amp. socket.If a new plug is to be fitted please observe the wiring code as shown below.If in any doubt please consult a qualified electrician.How to replace the fuse (for plug type shown in example 1) :Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refitsecurely into the mains plug (See example 1).How to replace the fuse (for plug type shown in example 2) :Lift open the fuse compartment, in the mains plug, with a screwdriver, and replace the fuse,then press the fuse cover down securely. (See example 2).IMPORTANT :-- The wires in the mains lead of this appliance are coloured in accordance with the following code :--BLUE : NEUTRAL BROWN : LIVEAs the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in your plug,proceed as follows :--1. The BLUE wire must be connected to the terminal marked ‘N’ or coloured black.2. The BROWN wire must be connected to the terminal marked ‘L’ or coloured red.IMPORTANT NOTE : Under no circumstances should either of these wires be connected to the Earth terminal of the three pin plug,marked with the letter ‘E’ or the earth symbol.WARNINGS AND PRECAUTIONS