Panasonic TX-26LXD500 Operating Instructions Manual

Also see for TX-26LXD500: Service manual Service manual Service manual

Contents

Panasonic TX-26LXD500 Operating Instructions Manual Manual pdf 7 page image

712Connect the mains plug to the wall socket.Press the [ ] switch on the TV set to turn the set on.To switch the TV set to Standby mode, press the buttonon the remote control.The TV set can be switched on by pressing the buttonagain if it was in Standby mode.Note:This TV will still consume some power even in the Offmode, as long as the mains plug is still connected to alive mains socket.IDTV1 2 34 5 67 8 9C 0OKRemote control signal sensorPower IndicatorStandby : RedOn : No LightC.A.T.S. sensorLCD C.A.T.S. (Contrast Automatic TrackingSystem) automatically senses the ambient lightconditions and adjusts the brightness and gradationaccordingly, to optimize contrast.C.A.T.S. is in effect when Viewing mode is set toAuto. See page 11.Programmes will appear immediately if your dealer has programmed theTV for you.If the TV has not been programmed for you then Auto setup will begin.The TV will search for DVB stations and Analogue stations:TV stations will be located, sorted into order and stored ready for use.Stations are sorted into the following order:• DVB Stations: Are sorted by their logical channel number sent by thebroadcasters, which can be made the favourites list by Profile Edit. Seepage 24.• Analogue Stations: Are sorted into channel order, but can be changedto your preference. See page 15.In this setup, usually Analogue auto setup screen may not be displayed.The sorted programme order depends upon the TV signal, the broadcastingsystem, and reception conditions.TV to VCR or DVD Recorder DownloadIf a “Q-Link”, “NEXTVIEWLINK” or compatible recording device hasbeen connected to a Scart terminal (AV2 or AV4) before starting Step 1,programme information will be downloaded to that device.Only the analogue programme positions will be downloaded to therecording device, in the same order as stored in the TV. See page 32.Not all VCRs / DVD Recorders support this download of programme information, some may require to bestarted manually.Refer to the recording device’s operating instruction book.If a recording device other than those described above has been connected, then there will be no downloadoperation.Notes:• If the recording device has not accepted download data from the TV, you may need to select the Downloadoption from the device’s menu system. Refer to the recording device’s operating instruction book.• If Q-Link is not operating correctly, check the following :The Scart cable is connected to the TV’s Scart terminal, AV2 or AV4, and correctly setup in the menu.The Scart cable is connected to the recording device’s compatible (Q-Link, NEXTVIEWLINK or similartechnology) Scart terminal.The Scart cable is a “fully wired” type.• For further information on Q-Link and connecting equipment, see page 32, 51, 56.DOWNLOAD IN PROGRESSPLEASE WAITProgramme : 63Remote control unavailableAUTO SETUP IN PROGRESSSEARCHING : PLEASE WAIT21 68CH44ExitPlease Wait !DVB Aute SetupProg. Channel Service Name NetID. TS ID. QualityThis will take about 3 mins.Exit45678303030303012302123021230212302123024158415841584158415899999BBC NEWS 24BBCICBBC ChannelBBC Radio WalesBBC Radio Cymru6821Quick Start Guide3DVB IndicatorDVB system active during Timer recording orstandby for Direct TV Recording : Orange (flash)Timer recording On : OrangeOtherwise : No Light