Panasonic TX-26LXD500 Operating Instructions Manual

Also see for TX-26LXD500: Service manual Service manual Service manual

Contents

Panasonic TX-26LXD500 Operating Instructions Manual Manual pdf 53 page image

LRPC INAUDIO INRGBAVVIDEOVIDEOS-VIDEOLYPBP RRAUDIOLRAUDIORGBVIDEOS-VIDEOVIDEOCOMPONENTAUDIO INPCAV1 AV2 AV453ConnectionsHow to connect the PC Input terminal167839451015 14 13 12 112Notes:• Connect a cable which matches the audio output terminal on the computer.• Computer signals which can be input are those with a horizontal scanning frequency of 31 to 69 kHz and verticalscanning frequency of 59 to 86 Hz. (However, the image will not be displayed properly if the signals exceed 1,024lines.)• When the aspect mode is set to “4:3”, maximum of 1,024 x 768 dots area of LCD panel is used for display, and whenthe aspect mode is set to “16:9”, full area (1,366 x 768 dots) of LCD panel is used for display.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.• For applicable PC signals information see page 57.Signal Names for D-sub 15P ConnectorPin Layout for PC InputTerminalCOMPUTERRGBAUDIO(D-sub 15p)(Stereo plug)Conversion adapter (if necessary)Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name1 R 6 GND (Ground) 11 NC (not connected)2 G 7 GND (Ground) 12 NC (not connected)3 B 8 GND (Ground) 13 HD/SYNC4 NC (not connected) 9 NC (not connected) 14 VD5 GND (Ground) 10 GND (Ground) 15 NC (not connected)Example: