Panasonic TX-26LX60LA Operating Instructions Manual

Panasonic TX-26LX60LA Operating Instructions Manual Manual pdf 7 page image

7Quick Start GuideDOWNLOAD IN PROGRESSPLEASE WAITProgramme : 63Remote control unavailableTV to VCR or DVD Recorder DownloadIf a “Q-Link”, “NEXTVIEWLINK” or compatible recording device has beenconnected to a Scart terminal before starting Step 1, programme informationwill be downloaded to that device.3The programme positions will be downloaded to the recording device, in the same order as stored in the TV.See page 21.Not all VCRs / DVD Recorders support this download of programme information, some may require to bestarted manually.Refer to the recording device’s operating instruction book.If a recording device other than those described above has been connected, then there will be no downloadoperation.Notes:• If the recording device has not accepted download data from the TV, you may need to select the Downloadoption from the device’s menu system. Refer to the recording device’s operating instruction book.• If Q-Link is not operating correctly, check the following:The Scart cable is connected to the TV’s Scart terminal, AV1 or AV2, and correctly setup in the menu.The Scart cable is connected to the recording device’s compatible (Q-Link, NEXTVIEWLINK or similartechnology) Scart terminal.The Scart cable is a “fully wired” type.• For further information on Q-Link and connecting equipment, see page 21, 29, 32.AUTO SETUP IN PROGRESSSEARCHING : PLEASE WAIT01 99:21 41CH12Exit2 Programmes will appear immediately if your dealer has programmedthe TV for you.If the TV has not been programmed for you then Auto setup willbegin.The TV will search for Analogue stations:TV stations will be located, sorted into order and stored ready foruse.Analogue stations are sorted into channel order, but can be changed to your preference. See page 15.The sorted programme order depends upon the TV signal, the broadcasting system, and receptionconditions.1 Connect the mains plug to the wall socket.Press the [ ] switch on the TV set to turn theset on.To switch the TV set to Standby mode, pressthe button on the remote control.The TV set can be switched on by pressing thebutton again if it was in Standby mode.Note:This TV will still consume some power as longas the mains plug is still inserted into the wallsocket. TVN1 2 34 5 67 8 9C 0OKRemote control signal sensorPower IndicatorStandby : RedOn : No LightRed light indicates Standby mode.When using remote control, this indicates the TV has received a command.