Panasonic TX-26LX60LA Operating Instructions Manual

Panasonic TX-26LX60LA Operating Instructions Manual Manual pdf 4 page image

4Warnings and PrecautionsFOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLYThis appliance is supplied with a fitted three pin mains plug for your safety and convenience. A 5 amp fuse is fittedin this plug. If the fuse is replaced then the replacement fuse must be 5 amp rated and should be approved byASTA or BSI to BS1362.Check for the ASTA mark ASA or the BSI mark on the body of the fuse.If the fitted plug has a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you losethe fuse cover the plug must not be used until a replacement cover is obtained. Replacement fuse covers can bepurchased through your local Panasonic dealer.The plug fitted to this appliance incorporates a mains filter circuit. If this is removed orreplaced with a non– filtered plug this television will no longer meet the European standardsfor Electromagnetic Compatibility (EMC). If the fitted plug is unsuitable for the socket outletin your home an appropriate adapter should be used.Nonetheless, if the fitted plug is replaced, the fuse should be taken out and the cut- off plugdisposed of safely. There is danger of severe electrical shock if the cut off plug is insertedinto any 13 amp socket.If a new plug is to be fitted please observe the wiring code as shown below.If in any doubt please consult a qualified electrician.How to replace the fuse (for plug type shown in example 1):Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refit securely into the mainsplug (see example 1).How to replace the fuse (for plug type shown in example 2):Lift open the fuse compartment, in the mains plug, with a screwdriver, and replace the fuse, then press the fusecover down securely (see example 2).Example 1Example 2IMPORTANT: – The wires in the mains lead of this appliance are coloured in accordance with the following code:–BLUE : NEUTRAL BROWN : LIVEAs the colours of the wires in the mains lead of this appliance may not correspond to the markings identifying the terminals in yourplug, proceed as follows:–1. The BLUE wire must be connected to the terminal marked ‘N’ or coloured black.2. The BROWN wire must be connected to the terminal marked ‘L’ or coloured red.IMPORTANT NOTE: Under no circumstances should either of these wires be connected to the Earth terminal of the three pin plug,marked with the letter ‘E’ or the earth symbol .Fitting remote control batteries• Make sure that the batteries are fitted the correct way round.• Do not mix old batteries with new batteries. Remove old, exhausted batteries immediately.• Do not mix different battery types, i.e. Alkaline and Manganese or use rechargeable (Ni-Cd, Ni-MH) batteries.++--Pull and hold the hook, thenopen the battery cover.Insert batteries - note correctpolarity ( + and -).“R6 (UM3)” sizeReplace the cover.321