SERIALPC INAUDIOSLOT1 SLOT3PR /CR /R P B/C B/B Y/GCOMPONENT/RGB INLANSLOT2AUDIO AUDIODVI-D IN1 212 12128ConnectionsSpeakerterminal (R)Speakerterminal (L)When connecting the speakers, be sure to use only the optional accessory speakers.Refer to the speaker’s Installation Manual for details on speaker installation.AC cord connection (see page 12)Speakers (Optional accessories)Pass the attached cablefixing band through the clipas shown in the figure.To secure cables connected to Terminals, wrap the cable fixing band around themthen pass the pointed end through the locking block, as shown in the figure.While ensuring there is sufficient slack in cables to minimize stress (especiallyin the power cord), firmly bind all cables with the supplied fixing band.To tighten: To loosen:PullPullPush the catch– AC cord fi xingNote: Terminal board is installed in SLOT 2 and SLOT 3 at factory shipment.– Cable fi xing bandSecure any excess cables with band as required.Note:One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.Note:Make sure that the ACcord is locked on both theleft and right sides.Pushuntilthe hookclicks.2. Pulloff.CloseOpen1 Plug the AC cord into the displayunit.Plug the AC cord until it clicks.2 Fix the AC cord with the clamperwhich is attached to the unit.For the TH-58PF12EK :Clampers are not installed to thisunit. Ensure there is sufficient slackin the AC cord and firmly bind withthe supplied cable fixing band, etc.1. Keep theknobpressed.Unplug the AC cordUnplug the ACcord pressingthe two knobs.Note:When disconnecting the AC cord,be absolutely sure to disconnectthe AC cord plug at the socketoutlet first.From SERIALTerminal onComputer(see page 10)From EXTERNALmonitor terminalon Computer(see page 9)DVI-D IN Terminals(equivalent of DVI-DTerminal Board(TY-FB11DD))(see page 11)Optional TerminalBoard Insert Slot(covered)COMPONENT/RGB INTerminals(see page 11)LAN Terminal(see page 57)