250005PictureNormalNormaliseNormalBrightnessSharpnessPicture ModeColourContrastHueColour ManagementAdvanced settingsWhite balance NormalOffBlack extensionAGCGammaInput levelAdvanced settingsNormalNormaliseW/B Low BW/B High RW/B Low RW/B Low GW/B High GW/B High B002.2000000Off2612Press to display the Picture menu.Press to select the menu to adjust.Select the desired level by looking at the picture behind the menu.Select to adjust each item.Press “ ” or “ ” button to switch between modes.While the “Picture” menu is displayed, if either the N button on the remote control is pressed at any time or theACTION ( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.Helpful Hint ( / Normalise Normalisation)Colour Management OnEnables vivid colour adjustment automatically.Note:Menu that cannot be adjusted is grayout. Adjustable menu changes depending on signal,input and menu setting.Picture AdjustmentsNormal Cool WarmPress “ ” or “ ” button to switch between modes.NormalMonitorDynamicCinemaNormalFor viewing in standard (evening lighting) environments.This menu selects the normal levels of Brightnessand Contrast.DynamicFor viewing in brighter environments.This menu selects higher than normal levels ofBrightness and Contrast.CinemaIdeal for movies.MonitorFor use when creating broadcast or movie content.With this picture, even if the overall average picturelevel (APL) changes, the brightness of areas withthe same signal level does not change.Notes:• When “Monitor” is selected in Picture Mode, thefollowing menu items cannot be set.Picture menu: ContrastExtended life settings: Peak limit (see page 36)Setup menu: Power save (see page 38)MULTI DISPLAY Setup menu: AI-synchronization(see page 42)Portrait Setup menu: AI-synchronization (see page 45)• If you would like to change the picture and colour ofthe selected Picture menu to something else, adjustusing the items in the Picture menu. (see next page)Advanced settings OnEnables fine picture adjustment at a professionallevel (see next page).Press to enterAdvanced settings.