35Touch-Pen SettingsStandby pen charging modeSets the power supply for the electronic pen charging terminal (CHARGE, MEMORY/(CHARGE)) in the standby mode(power OFF with remote control).Off: Turns off the charging terminal power in the standby mode.On[4hrs]: Turns ON the charging terminal power for 4 hours after entering standby mode.On: Leaves the charging terminal power ON in standby mode so that the pen can be charged.PairingRegisters an electronic pen to electronic pen adapter.Up to four electronic pens can be registered for an electronic pen adapter.For the details of the pairing, please refer to “Operating Instructions, Electronic Pen Operations”.Note:Make sure the electronic pen adapter is connected to the display.[Unpairing]Unpairs all paired electronic pens.1122345Select “Pairing” in “Touch-Pen Settings” and pressbutton.Select “Unpairing All” in “Pairing Tool” and press button.Select “Yes” and press button.Select “Pairing” and press button.While pressing both the remote drawing and the remoteclearing buttons of the electronic pen, press the Powerswitch.To cancel the paring, select “Cancel”.When the electronic pen paring is completed,select “Return” and press button.Select “Close” and press button.If no electronic pen has been registered, the screen of procedure 3 appears first. Follow the instructionson the screen to register an electronic pen.Pairing ToolCloseUnpairing AllPairingPairing ToolCloseUnpairing AllPairingPairing ToolPairing was successful.ReturnPairing in progressSet the electronic pen that you want to pair aspair-enabled and then move it closer to theelectronic pen adapter. For details, refer to theprocedure for registering electronic pens in theoperating instructions for the electronic pen.CancelPairing ToolNoDo you want to cancel all pairings?Yes