Panasonic TH-49LFV8U Operating Instructions Manual

Also see for TH-49LFV8U: Operating instructions

Contents

Panasonic TH-49LFV8U Operating Instructions Manual Manual pdf 9 page image

Clean the power cable regularly to prevent itbecoming dusty.• If dust built up on the power cord plug, the resultanthumidity can damage the insulation, which couldresult in fire. Pull the power cord plug out from thewall outlet and wipe the mains lead with a dry cloth.Do not step on, or hang from the display.• They might tip over, or might be broken and it mayresult in injury. Pay special attention to the children.Do not reverse the polarity (+ and -) of the batterywhen inserting.• Mishandling the battery may cause its explosionor leakage, resulting in fire, injury or damage tosurrounding properties.• Insert the battery correctly as instructed. (see page10)Do not use batteries with the outer cover peelingaway or removed.(The outer cover is attached to the battery for safety.It must not be removed. Doing so may cause shortcircuits.)• Mishandling the batteries may cause the batteriesto short circuit, resulting in fire, injury or damage tosurrounding properties.Remove the batteries from the remote controltransmitter when not using for a long period of time.• The battery may leak, heat, ignite or burst, resulting infire or damage to surrounding properties.Do not burn or breakup batteries.• Batteries must not be exposed to excessive heat suchas sunshine, fire or the like.Do not turn the Display upside down.Do not position the unit with its liquid crystal panelfacing upright.Precautions for useUnpacking• This product is packed in a carton, together with thestandard accessories.• Any other optional accessories will be packedseparately.• Due to the size and weight of this display it isrecommended for two people to move it.• After opening the carton, ensure that the contents arecomplete and in good condition.Cautions when installingDo not set up the Display outdoors.• The Display is designed for indoor use.Install this unit at a location which can support theweight of the unit.• Use the installation bracket that conforms to VESAstandardsEnvironmental temperature to use this unit• When using the unit where it is below 1 400 m (4 593ft) above sea level: 0 °C to 40 °C (32 °F to 104 °F)• When using the unit at high altitudes (1 400 m (4 593ft) and higher and below 2 800 m (9 186 ft) above sealevel): 0 °C to 35 °C (32 °F to 95 °F)Do not install the unit where it is 2 800 m (9 186 ft)and higher above sea level.• Failure to do so may shorten the life of the internalparts and result in malfunctions.We are not responsible for any product damage, etc.caused by failures in the installation environmenteven during the warranty period.Do not place the display where it may be affected bysalt or corrosive gas.• Failure to do so may shorten the life of the internalparts and result in malfunctions due to corrosion.Required space for ventilation• For the outermost periphery of the display, leave aspace of 10 cm (3.94”) or more at the top, bottom, leftand right.At the rear, leave a space of 5 cm (1.97”) or more.About the screws used when using a wall hangingbracket that conforms to VESA standardsInchmodelScrew pitch forinstallationDepth ofscrewholeScrew(quantity)49/55 400 mm × 400 mm 10 mm M6 (4)• Installing multiple displaysWhen installing multiple displays, the LCDs maydilate due to temperature change inside the main unit,resulting in malfunction.7English