31TH-47LFT30W8.22. How to remove the handlesTake the following steps to change the handles when the han-dle gets damaged, etc.1. Undo the screws shown in the drawing to remove thehandle from the back plate together with the metal holderfitting. (SPECIAL SCREW 4X10)2. Undo the screws shown in the drawing to remove thehandle from the metal holder fitting. (SPECIAL SCREW5X12)When replacing the handle with replacement part, reusethe existing metal holder fitting because the metal holderfitting is not a replacement part.8.23. How to replace the AV cover(bottom)1. Undo the ten screws to remove the AV cover (bottom)from the back plate. (SPECIAL SCREW 4X12)2. Replace it with the replacement AV cover bottom (bot-tom).The replacement AV cover (bottom) is a single unit partincluding gasket and gel for the wire outlet.8.24. Position for the hook holdscablesThe position for fitting the hook for holding cables, etc. is asshown in the drawing of the metal fitting A and B for the chassisbase.8.25. How to replace the cabinetback1. Remove the main switch board, RC LED board, and thepower cord from the cabinet back.2. Undo eight screws to remove the metal panel holder fit-tings. (SCR BIN+SW+W 4X10)3. Replace it with the replacement cabinet back.