12TH-47LFT30W4 SpecificationsFor USA, Canada and Mexico For Europe and AsiaPower Source 110 - 127 V AC, 50/60Hz 220 - 240 V AC, 50/60 HzPower ConsumptionPower on 310 W 300 WStand-by condition Save off 0.2 W, Save off 0.3 W,(Winter Mode: Off) Save on 0.1 W Save on 0.2 WStand-by condition Backlight Off 40 W Backlight Off 40 W(Winter Mode: On) Backlight On 110 W Backlight On 110 WPower off condition 0.1 W 0.2 WLCD Display panel 47-inch IPS panel, 16:9 aspect ratioScreen size 40.9 inch (W) × 23.0 inch (H) × 46.9 inch (diagonal) /1,039 mm (W) × 584 mm (H) × 1,192 mm (diagonal)(No. of pixels) 2,073,600 (1,920 (W) × 1,080 (H))[5,760 × 1,080 dots]Operating conditionTemperature 32 °F - 113 °F / 0 °C - 45 °C* 1 (during Winter Mode: -4 °F - 113 °F / -20 °C - 45 °C)* 1Applicable signalsScanning format 525 (480) / 60i 60p, 625 (575) / 50i 50p, 750 (720) / 60p 50p, 1125 (1080) /60i 60p 50i 50p 24p 25p 30p 24sFPC signals VGA, SVGA, XGA, SXGAUXGA ..... (compressed)Horizontal scanning frequency 30 - 110 kHzVertical scanning frequency 48 - 120 HzConnection terminalsHDMI 1/2 TYPE A ConnectorDVI-D IN DVI-D 24 Pin Compliance with DVI Revision 1.0Content Protection Compatible with HDCP 1.1AUDIO Stereo mini jack (M3) × 1 0.5 Vrms, Shared with PC INPC IN High-Density Mini D-sub 15 Pin G with sync 1.0 Vp-p (75-ohm)G without sync 0.7 Vp-p (75-ohm)B:0.7 Vp-p (75-ohm)R:0.7 Vp-p (75-ohm)HD / VD:1.0 - 5.0 Vp-p (high impedance)AUDIO Stereo mini jack (M3) × 1 0.5 Vrms, Shared with DVI-D INSERIAL External Control TerminalD-sub 9 Pin RS-232C compatibleTOUCH PANEL USB2.0 compatibleI/F connector: TYPE BEXT SP 8-ohm, 10 W [5 W + 5 W] (10 % THD)Accessories SuppliedRemote Control Transmitter N2QAYB000535* 2Batteries (R6 (UM3) Size × 2)Dimensions (W × H × D) 45.3 inch × 27.4 inch × 10.7 inch1,149 mm × 694 mm × 271 mmMass (weight) approx. 136.7 lbs / 62.0 kg* 1 Use the product at ambient temperatures below 104 °F/40 °C at an installation site where the liquid crystal panel is exposed to sunlight.* 2 Remote Control Transmitter is not water protection type.Notes:• Design and specifications are subject to change without notice. Mass and dimensions shown are approximate.• This equipment complies with the EMC standards listed below.EN55022, EN55024, EN61000-3-2, EN61000-3-3.