Panasonic TH-42PH30U Operating Instructions Manual

Also see for TH-42PH30U: Specifications Operating instructions

Contents

Panasonic TH-42PH30U Operating Instructions Manual Manual pdf 45 page image

When Image input and Audio inputdiffer from each other, the Audioinput is displayed as below.Options AdjustmentSet up the sound when an image input is selected.Image input Audio input[VIDEO] VIDEO / COMPONENT / DVI / PC / NO AUDIO[COMPONENT]* VIDEO / COMPONENT / DVI / PC / NO AUDIO[HDMI] VIDEO / COMPONENT / HDMI / DVI / PC / NO AUDIO[DVI] VIDEO / COMPONENT / DVI / PC / NO AUDIO[PC] VIDEO / COMPONENT / DVI / PC / NO AUDIONO AUDIO: No audio input (Mute)* “COMPONENT” may be displayed as “RGB” depending on the setting of“COMPONENT/RGB-IN SELECT”. (see page 37)Note:HDMI Audio is selectable only for HDMI Input.Audio input selectPress to select image input.Press to select audio input.PCCOMPONENTFULLPress ACTION ( ) buttonPress ACTION ( ) buttonVIDEOAudio input selectCOMPONENTHDMIDVIPC♪ VIDEO♪ COMPONENT♪ HDMI♪ DVI♪ PCOptionsAudio input selectTouch Panel settings1/3OptionsAudio input selectTouch Panel settings1/3Touch Panel modeCalibration modeTouch Panel settingsOnTouch Panel modeCalibration modeTouch Panel settingsOnThe screen is displayed in the middle and NANODRIFT is deactivated for 180 seconds.After 180 seconds or when you have the menu displayed with a remote control, Calibrationmode is cancelled.Note:For information on how to set up Calibration, please see Touch Panel instruction manual.The mode to restrict NANODRIFT SAVER (see page 30) operation when using Touch Panel (available as an option) isset up.Set “Touch Panel mode” to “On”.Select “Calibration mode” and then press .This setting is used in calibrating a touch panel.You can configure the setting if “Touch Panel mode” is “On”.Calibration modeTouch Panel settings (Settings when using Touch Panel)ªCalibration mode1 select2 adjust1 select2 setNANODRIFT SAVER in Touch Panel mode: OnThe value set for NANODRIFT turns into “ON” and displayedin gray.The moving distance of NANODRIFT is limited to 3 × 3 dots toprevent pointer drift on a touch panel.When the menu is not displayed(normal screen)Hold down for over 3 seconds.45