Panasonic TH-42PH30U Operating Instructions Manual

Also see for TH-42PH30U: Specifications Operating instructions

Contents

Panasonic TH-42PH30U Operating Instructions Manual Manual pdf 22 page image

0NORMALNORMALIZEAUTO SETUPPOS./SIZEV-POS0H-POSV-SIZEDOT CLOCKH-SIZECLOCK PHASE0CLAMP POSITIONOVER SCAN0000Note:Unadjustable items are grayed out.Adjustable items differdepending on the input signaland the display mode.22Adjusting POS./SIZE1 Press to display the POS./SIZE menu.Press to select the menu to adjust.Press to adjust the menu.Press to exit from adjust mode.Notes:• Adjustment details are memorized separately for different input signal formats. (Adjustments for component signals arememorized for 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 1125 (1080) / 60i · 50i · 60p · 50p · 24p · 25p · 30p · 24sF,750 (720) / 60p · 50p each, and RGB/PC/Digital signals are memorized for each frequency.)• If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This pictureposition movement cannot be controlled by the POS./SIZE function.234AUTOSETUPWhen inputting a PC signal as an example, “H-POS/V-POS”, “H-SIZE/V-SIZE”, “DOT CLOCK” and “CLOCKPHASE” are automatically corrected.This setting is enabled under the following conditions:• This setting is not activated during Multiple display or Digital Zoom.• When inputting an analog signal (Component/PC):This setting is enabled if “COMPONENT/RGB-IN SELECT” (see page 37) in SET UP menu is “RGB”.• When inputting a digital signal (HDMI/DVI):A PC format signal enables this setting.If other than a PC format signal, this setting is enabled with “OVER SCAN” (see page 23) set to “OFF”,and H-SIZE/V-SIZE cannot make automatic corrections.This setting will be invalid and will not work under the following conditions:• When VIDEO signal input• Aspect is set to “JUST”• “Display size” in the Options menu (see page 43) is set to “On”Using Remote ControlWhen on the remote control is pressed, “AUTO SETUP” will be executed.When AUTO SETUP does not work, “INVALID” is displayed.Auto modeWhen the “Auto Setup“ is set to “Auto” in the Options menu (see page 44), automatic position adjustment starts:• When the display power is turned ON.• When the input signal is switched.