10Network SetupWIRED LANYou can make detailed wired LAN settings.Select [WIRED LAN] in [NETWORK SETUP] menu and press1 button.Set [DHCP].2 When [OFF] is selected, IP ADDRESS and other settings can be set manually.DHCP(DHCP client function)ON: If a DHCP server exists in the network to which the displayis connected, the IP address will automatically be acquired.OFF: If a DHCP server does not exist in the network to whichthe display is connected, additionally set [IP ADDRESS],[SUBNET MASK] and [GATEWAY].IP ADDRESS(Display of IP address and setting) Enter the IP address if DHCP server is not used.SUBNET MASK(Displaying and setting the subnet mask) If not using a DHCP server, enter the subnet mask.GATEWAY(Display of gateway address and setting) Enter the gateway address if DHCP server is not used.If [DHCP] is set to [ON], the IP address and other items are not displayed. Check the [STATUS] page for thecurrent IP address and other items. (See page 17)Select [SAVE] and press3 button.Save the current network settings.If message indicating a duplicate IP address is displayed in [STATUS] (see page 17), check the same IPaddress is not used within the same network.Before using the DHCP server, make sure the DHCP server is already functioning.•For details of IP address, subnet mask, and gateway, ask the network administrator.•A wired LAN and wireless LAN cannot be used in the same segment.• Default wired LAN settingsThe following settings are set before the Display leaves the factory.DHCP OFFIP ADDRESS 192.168.10.100SUBNET MASK 255.255.255.0GATEWAY 192.168.10.1WIRED LANSAVEDHCP192.168. 0. 1255.255.255. 0192.168. 10.100OFFIP ADDRESSSUBNET MASKGATEWAYAddress settings1 Select the item and press .I192.168. 0. 8IP ADDRESS2 Use to select a digit.3 Use to change a number.4 Press .Pressing will cancel the address change.