Panasonic TH-42LFP30W Operating Instructions Manual

Also see for TH-42LFP30W: Brochure Specification Operating instructions Service manual

Contents

Panasonic TH-42LFP30W Operating Instructions Manual Manual pdf 20 page image

6 7 8 91 3 4 52COMPUTERRS-232C Straight cableD-sub 9p(Female) (Male)12SERIAL Terminals connectionNotes:• Use the RS-232C straight cable to connect the computer to the Display.• The computer shown is for example purposes only.• Additional equipment and cables shown are not supplied with this set.The SERIAL terminal conforms to the RS-232C interfacespecification, so that the Display can be controlled by acomputer which is connected to this terminal.The computer will require software which allows thesending and receiving of control data which satisfiesthe conditions given below. Use a computer applicationsuch as programming language software. Refer to thedocumentation for the computer application for details.The SERIAL terminal is used when the Display is controlled by a computer.Pin layout for SERIAL TerminalBasic format for control dataThe transmission of control data from the computerstarts with a STX signal, followed by the command, theparameters, and lastly an ETX signal in that order. If thereare no parameters, then the parameter signal does notneed to be sent.STX C1 C2 C3 P1 P2 P3 P4: P5 ETXStart(02h)3-charactercommand (3 bytes)Colon Parameter(s)(1 - 5 bytes)End(03h)Notes:• If multiple commands are transmitted, be sure to wait forthe response for the first command to come from this unitbefore sending the next command.• If an incorrect command is sent by mistake, this unit willsend an “ER401” command back to the computer.• Consult an Authorized Service Center for detail instructionson command usage.Communication parametersSignal level RS-232C compliantSynchronization method AsynchronousBaud rate 9600 bpsParity NoneCharacter length 8 bitsStop bit 1 bitFlow control -Signal names for D-sub 9P connectorPin No. Details2 R X D3 T X D5 GND4 • 6 Non use78 (Shorted in this set)1 • 9 NCThese signal names are those of computer specifications.ConnectionsCommandCommand Parameter Control detailsPON None Power ONPOF None Power OFFAVL ** Volume 000 - 100AMT 0 Audio MUTE OFF1 Audio MUTE ONIMS NoneAV1AV2HM1HM2DV1PC1Input select (toggle)VIDEO input (VIDEO)COMPONENT/RGB IN input(Component)HDMI1 input (HDMI1)HDMI2 input (HDMI2)DVI-D IN input (DVI)PC IN input (PC)DAM NoneZOOMFULLNORMZOM2Screen mode select (toggle)Zoom116:94:3Zoom2With the power off, this display responds to PON commandonly.