Panasonic RX-ES23 Operating Instructions Manual

Also see for RX-ES29: Operating instructions Operating instructions

Contents

Panasonic RX-ES23 Operating Instructions Manual Manual pdf 7 page image

7RQT7914The RadioPreparation:≥ When using batteries, press [ ].≥ Press [TUNER BAND] to select “FM” or “AM”.Manual tuning[1] Press [REW/–/6] or [5 /+/FF] to select a station.To tune automaticallyPress and hold [REW/–/6] or [5/+/FF] until thefrequency starts changing rapidly.≥ Auto tuning may be interrupted when there is excessiveinterference.≥ To cancel auto tuning, press [REW/–/6] or [5/+/FF]once again.[2] Press [+, – VOLUME] to adjust volume.To use auto scanYou can search for a station by listening to all tuned-in stationsfor 8 seconds each.[1] Press [AUTO SCAN].[2] Press [AUTO SCAN] when you find the desired station.Auto scan ends when it reaches the original frequency again.To stop during the process, press [AUTO SCAN].To improve FM sound qualityPress [PLAY MODE] to display “ ”.Monaural sound is selected and noise reduces when reception is weak.Press [PLAY MODE] again to cancel the mode.≥ To improve receptionFM : Change the length and direction of the antenna.AM : Change the facing of the unit.≥ AM reception is briefly interrupted if [< DECK] is pressed.≥ To improve reception when using the unit in a building orvehicle, place it near a window.AM allocation settingOnly from the main unitBefore receiving AM broadcasts, be sure to select the correctallocation setting (either 9 kHz or 10 kHz) for your area.1 Press [TUNER BAND] to select FM.2 Press and hold [TUNER BAND] for approximately 5 seconds.The frequency display will be returned to the minimum frequencyof the AM band and the display will begin to flash. Keep holdingfor approximately 5 more seconds.3 When the display stops flashing and indicates adifferent frequency number, release [TUNER BAND].To return to the original frequency, repeat steps 1 to 3 above.Note:≥ After changing the “allocation” setting, the frequencies youpreviously preset into the memory will be cleared.Preset tuningUp to 16 stations can be set in the FM and AM band.[1] Press [REW/–/6] or [5/+/ FF] to tune to therequired station.[2] Press [ MEMORY CLEAR].[3] While “ ” is flashingTurn [TIME/PRESET TUNE TRACK SKIP ] to selectthe channel and press [ MEMORY CLEAR] or on remotecontrol, press the numeric buttons to select channels.≥ For channels 1 to 9, press the corresponding number.≥ For channels 10 to 16, press [S10], then the two digits.If “ ” goes off during presetting, return to step [1].To select channelsTurn [TIME/PRESET TUNE TRACK SKIP ] toselect the channel or on remote control, press thenumeric buttons to select channels.To use preset scanYou can search for a station by listening to all preset channelsfor 8 seconds each.[1] Press and hold [C/: ALBUM] or [ALBUM 9/D] until “PS” appears on the display.[2] Press [C/: ALBUM] or [ALBUM 9/D] whenyou find the desired channel.Preset scan ends after searching through each preset channelonce. To stop during the process, press [C/: ALBUM] or[ALBUM 9/D].To skip the preset channel,1 Select the desired station.2 Press [ MEMORY CLEAR].3 While “ ” is flashingTurn [TIME/PRESET TUNE TRACK SKIP ] to display “– –”.4 Press [ MEMORY CLEAR].To select the skipped channel,Press the numeric buttons.VOLUMER E WAMFM