Panasonic RX-ES23 Operating Instructions Manual

Also see for RX-ES29: Operating instructions Operating instructions

Contents

Panasonic RX-ES23 Operating Instructions Manual Manual pdf 11 page image

11RQT7914ALL-REC [CD-DA]Records the whole CD or selected tracks. When the tapefinishes before CD, recording and CD pauses for you to resumerecording on the opposite side.[1] Press [∫ TAPE/CD] to switch to CD mode.[2] Press [CD REC MODE] to display “ALL-REC”.Each time you press the button:The display shows the tape length needed.“C – – – –” indicates the tape needed exceeds 100 minutes.You can still record, but some tracks may not be recorded ifthe tape is not long enough.[3] Press [< DECK] to open the deck and load acassette with the side for recording facing up.[4] Press [¥/;] to start recording.The unit rewinds the tape, records 10 seconds of silence,and then starts recording.To stop recording, press [∫ TAPE/CD]. The CD also stops.If a track is interrupted at the end of the side facing up,Recording and CD pauses.§The unit records 10 seconds of silence, and resumesrecording from the beginning of the cut-off track.Note:≥ Random play and repeat play cannot be used with“ALL-REC”.1-REC [CD-DA] [MP3]Records a selected track from the CD and stops.Preparation:Wind on the tape to where you want to start recording.[1] Press [∫ TAPE/CD] to switch to CD mode.[2] Press [CD REC MODE] to display “1-REC”.[3] Turn [TIME/PRESET TUNE TRACK SKIP ] toselect the track you want to record.[4] Press [¥/;] to start recording.CD play and recording start at the same time.Note:≥ Recording and CD will stop when the tape reaches its end,even if the track has not finished.Recording the RadioPreparation:To record from the beginning of the tape;Wind on the leader tape.To record from part or half way through the tape;Wind on the tape to where you want to start recording.[1] Load a cassette with the side for recordingfacing up.[2] Tune to the station.[3] Press [¥/;] to start recording.To reduce noise when recording AM (Beat Proof function)Remote control only1 Press [PLAY MODE] while recording.Each time you press the button:bP1 ,-. bP2Choose the setting with the least noise.To Operationsstop recording Press [∫ TAPE/CD].pause recording Press [¥/;].continue recordingfrom another CD onthe same cassetteduring pause or stop.1 Press [< CD] and replacethe CD.2 Press [¥/;].Press again to resumerecording.record selected tracks 1 Do step [1] and [2], thenprogram the tracks. (l 9)2 Press [¥/;].skip unwanted tracks 1 Press [¥/;] to pauserecording. (The CD alsopauses.)2 Turn [TIME/PRESET TUNETRACK SKIP ] so thenext track you want to record isdisplayed.3 Press [¥/;] to resumerecording.To Operationsrecord the track againon the opposite side1 Press [< DECK], flip thecassette, and insert it.2 Press [¥/;]. §ALL-REC 1-REC OFF## ]n===== ]n,=====To Operationsstop recording Press [∫ TAPE/CD].(The CD also stops.)continue recordingfrom another CD1 Press [< CD] and replace theCD.2 Do steps [3] and [4].record a track in play 1 Press [CD REC MODE] todisplay “1-REC”.2 Press [¥/;].Recording starts from thebeginning of the track and stopswhen the track finishes.To Operationsstop recording Press [∫ TAPE/CD].pause recording Press [¥/;].Press again to resume recording.