Panasonic NV-GS320 Operating Instructions Manual

Also see for NV-GS320: Operating instructions Operating instructions

Contents

Before using88VQT1A48Using the viewfinderª Extending the viewfinder1 Pull out the viewfinder and extend it bypinching the extension knob.≥The viewfinder will be activated. (If the LCDmonitor is opened, the viewfinder will bedeactivated.)ª Adjusting the field of view1 Adjust the focus by sliding the eyepiececorrector knob.≥You can adjust the brightness of the viewfinderfrom the menu.Quick StartWhen quick start is ON the battery power is stillbeing consumed, even when the LCD monitorand the viewfinder are closed.The movie camera will resume recording/pausemode about 1.7 seconds after the LCD monitor orthe viewfinder is reopended.≥Please note in quick start mode approximatelyhalf the pause recording power is beingconsumed. Using quick start mode will reducethe battery recording/playback time.≥This is only activated in the following cases.≥While using the batteryA tape or a card is inserted, while the TapeRecording Mode is set.A card is inserted, while the Card RecordingMode is set.≥While using the AC adaptorquick start can be used even if a tape/cardis not inserted.≥Set to Tape/Card Recording Mode.1 Set [SETUP] >> [QUICK START] >> [ON].(-94-)2 While the [OFF/ON] switch is still set to[ON], close the LCD monitor and retract theviewfinder.≥The Status indicator lights green and the unitgoes into quick start standby mode.≥The movie camera will not go into quick startstandby unless the LCD monitor is closed andthe viewfinder is retracted.3 Open the LCD monitor or extend theViewfinder.≥The Status indicator lights red and thecamera is put into recording pause approx.1.7 seconds after it is turned on.12:30:4512:30:4512:30:4515.10. 200715.10. 200715.10. 200712:30:4515.10. 2007OFF ONOFF ON