9Care and Cleaning of Your Microwave OvenBEFORE CLEANING:Unplug oven at wall outlet. If outlet is inacces-sible, leave oven door open while cleaning.AFTER CLEANING:Be sure to place the Roller Ring and the GlassTray in the proper position and pressStop/Reset Pad to clear the Display.Inside of the oven:Wipe with a damp clothafter using. Mild detergentmay be used if needed.Do not use harsh deter-gents or abrasives.Oven Door:Wipe with a soft, drycloth when steamaccumulates inside oraround the outside ofthe oven door. Duringcooking, especiallyunder high humidityconditions, steam isgiven off from thefood. (Some steamwill condense on cool-er surfaces, such asthe oven door. This isnormal.)Inside surface is cov-ered with a heat andvapor barrier film. Donot remove.Glass Tray:Remove and wash in warm soapywater or in a dishwasher.Outside oven surfaces:Clean with a damp cloth.To prevent damage to theoperating parts inside theoven, water should not beallowed to seep into ventila-tion openings.Do not remove waveguide cover:It is important to keep coverclean in the same manner as theinside of the oven.Control Panel:• Covered with aremovable protectivefilm to preventscratches duringshipping. Small bub-bles may appearunder this film.(Hint - To removefilm, apply maskingor clear tape to anexposed corner andpull gently.)• If the Control Panelbecomes wet, cleanit with a soft, drycloth. Do not useharsh detergents orabrasives.Roller Ring and oven cavity floor:Clean the bottom surface of the ovenwith mild detergent water or windowcleaner, and dry. Roller Ring may bewashed in mild soapy water or dish-washer. These areas should be keptclean to avoid excessive noise.IT IS IMPORTANT TO KEEP THE OVEN CLEAN AND DRY.FOOD RESIDUE AND CONDENSATION MAY CAUSE RUSTINGOR ARCING AND DAMAGE TO THE OVEN. AFTER USE, WIPEDRY ALL SURFACES-INCLUDING VENT OPENINGS, OVENSEAMS, AND UNDER GLASS TRAY.F00036K50CP 2004.1.19 16:04 Page 11