Panasonic NETWORK CAMERA WV-NW502S Installation Manual

Also see for WV-NW502S: Product catalog Product catalog Comparison chart Operating instructions Specifications

Panasonic NETWORK CAMERA WV-NW502S Installation Manual Manual pdf 27 page image

27Adjust the cameraz Be sure to view the monitor for adjust-ment when the camera angle is adjust-ed.Connect an adjusting monitor (such as asmall LCD monitor) to the monitor outconnector (for adjustment) and adjustthe camera angle.Turn on the power after connecting theadjusting monitor.Follow the steps q, w and e to adjustthe camera angle.q Loosen the panning lock screw,rotate the camera horizontally toadjust pan direction, and then tight-en the panning lock screw.w Loosen the tilting lock screw, rotatethe camera vertically to adjust tiltdirection, and then tighten the tiltinglock screw.e Rotate the tilt adjusting table toadjust the azimuth angle of the image.Note:• At the same time for the pan and tilt adjustments, make focus adjustments of Step 2.Important:• The panning lock and tilting lock screws shall be securely tightened.(Recommended tightening torque: 0.59 N·m {0.44 lbf·ft})x Adjusts the focus.At the same time for the pan and tilt adjustments, make focus adjustments.Adjust the focus by following the adjusting procedure of q, w and e shown below.q Hold down the auto back focus button for 5 sec. or more to set ABF to the standardposition.w Loosen the zoom lock lever andmove the lever between TELE andWIDE to obtain the appropriateangle of view.e Loosen the focus lock knob, rotatethe focus adjustment grip to adjustthe focus coarsely, and then tightenthe focus lock knob.* Refer to the operting instructions of thelens for the case of WV-NW502SK.( page 24)Note:

• If the zoom ring is fully rotated in the WIDE direction during use of a vari-focal lens, theperiphery may become dark depending on the lens to be used. In such a case, fully rotatethe focus ring in either the NEAR direction or FAR direction, slightly rotate the ring in thereverse direction, and adjust the back focus of the camera. For further information, refer tothe operating instructions for the lens to be used.LOCKLOCKPanning lock screw75 °Tilt adjusting tableMonitor out connectorfor adjustmentTilting lock screwPanning tableABFINITIALSETMONITOROUTFocus lock knobFocusadjustment gripZoom lock knob