Panasonic NC-ZA1 Operating Instructions Manual

Also see for NC-ZA1: Operating instructions

Contents

EN152 Turn the power on.1 Plug in and press the power button.• Make sure the waste container, water tank, drip tray and stainless steel plate are fitted.• Open the drip tray by pressing it. (Attention for drip tray display will show for 3 seconds after the espresso machine isheated up.)Heats up the machineautomatically.2 Press to start rinsing.• Make sure the drip tray is opened. Otherwise hot water will dispense onto the countertop.When rinsing is complete (dispense hotwater 4 times), the display will return tothe main menu. Wait until the displayshows the main menu.Note• When starting up for the first time or when the water tank wascompletely emptied, water suction may take a little longer dispensinghot water for rinsing cycle.• A small amount of water can get into the waste container during eachrinsing cycle. This is system-related and not a fault.• If is pressed during the rinsing cycle, it immediately stopsthe process.After flashes, the display will return to the previous display.• When dispensing hot water into the drip tray during rinsing cycle, youmay place the container under the dispenser.• During the rinsing, water is to collect in the drip tray.When water is full in the drip tray, the red float will be float up.• If the drip tray is closed with the red float is float up, the red float maybe stuck inside. Try to open the drip tray by pressing it. If it still doesnot open, remove the water tank and waste container and press downthe red float through the opening to remove the drip tray.Float