Panasonic MK-F310 Operating Instructions Manual

EN7EnglishOverload and Overheating ProtectionIn case of overload and overheating, the protection device is triggered to stop operation and it is notabnormal. After rotation stops, follow the below steps:● Do not use the appliance repeatedly without any countermeasure.1. Turn the rotary switch to "0" position, unplug the appliance.2. Remove the bowl from the motor housing. Reduce the ingredients to less than half.● Remove the prohibited ingredient if used.3. Reset the bowl, start blending again. (P. EN11 - EN12)If the appliance still does not operate after performing the above, the overheating protection has been activated.Turn the rotary switch to “0” position, unplug and rest the appliance for about 15 minutes or more (until motorhousing returns to a normal temperature) to release overheating protection before using again.(If appliance still does not operate, contact Panasonic Service Centre for inspection or repair.)Safety LockThe safety pin is designed to prevent the appliance from switching on when- The bowl lid and the bowl are not fully locked to each other.- The bowl is not fully locked to the motor housing.ABFully locking steps :For bowl, align the triangle mark with the motorhousing as shown in position A. Turn it clockwiseuntil a 'click' sound is heard and the triangularmark now aligns to position B.To unlock, follow the locking steps in reverse.Position A : UnlockPosition B : LockSafety PinsThe safety lever only activatesthe safety pin if the bowl lid issecured on the bowl.Note:• Do not push the safety pin and safety lever with any instrument, stick etc.• Do not pour liquids or ingredient at the safety pin and safety lever area.• Keep the safety pin and safety lever area clean to avoid foreign particles accumulate on the area.Actions above ensure the safety pin and safety lever function properly. If not followed, it will damage theparts related to the safety pin and safety lever.