3.1 Customising Your Phone (Personal Programming)User Manual 1993.1.3 Customising the ButtonsYou can customise the flexible buttons and/or programmable feature (PF) buttons on PTs, Add-on KeyModules, and PSs. They can then be used to make or receive outside calls or as feature buttons.• To enter the programming mode when using a PS, refer to "Operating Instructions" for PS.• The buttons in the table below can only be set on certain flexible buttons, as follows:– Flexible buttons on PTs/Add-on Key Modules/PSs: all buttons can be set.– Flexible buttons on DSS Consoles: all buttons except CTI and Primary Directory Number(PDN) buttons can be set.– Programmable feature (PF) buttons: only the One-touch Dialling button can be set.Button Programming InputLoop-CO (L-CO)Group-CO (G-CO) + Outside line group no. (2 digits)Single-CO (S-CO) + Outside line no. (3 digits)Direct Station Selection (DSS) + Extension no.One-touch Dialling* 1 + Desired no. (max. 32 digits)Incoming Call Distribution Group (ICDGroup) + Incoming call distribution group extension no. (++ delayed ringing time [0–7])* 3MessageMessage for Another Extension + Extension no./Incoming call distribution groupextension no.Call Forwarding (FWD)/Do NotDisturb (DND)—Both callsFWD/DND—Outside callsFWD/DND—Intercom callsPress PROGRAMor PAUSE.Press PROGRAMor PAUSE.Press desiredflexible button.To exitTo programmeTo enter the programming modeFollowprogramming input.To continueprogramminginputORPROGRAMPAUSEORPROGRAMPAUSEPress ENTERor STORE.ORAUTO DIALSTORE#012 *²3 0 #4 04 04 14 24 3
