4.1 Programming the PBX in the Los Angeles Office42 Getting Started4.1 Programming the PBX in the Los AngelesOfficeFor successful operation of a VoIP network using the VoIP Gateway Card as a QSIG networkinterface, the PBX at each location in the network must be programmed appropriately. For a detaileddiscussion of related features, refer to the Hybrid IP-PBX Feature Guide.This section details the procedure to programme the PBX in the Los Angeles office using theMaintenance Console (PC programming software of the PBX). After the PBX in the Los Angelesoffice has been fully programmed, repeat the procedure for the PBX in the Chicago office with theappropriate setting values.Notes• It is assumed that you have already installed the Maintenance Console (KX-TDA100/KX-TDA200: KXTDA Maintenance Console; KX-TDA600: KX-TDA600 Maintenance Console) inyour PC.• The screenshots shown in the installation procedure are based on the KX-TDA600Maintenance Console.• The contents and design of the software are subject to change without notice.1. Start the Maintenance Console from the Startmenu.2. a. Type the Installer Level Programmer Code(default: INSTALLER).b. Click OK.3. a. Click Connect → RS-232C or USB.b. In the next screen, type the system passwordfor installer (default: 1234).c. Click OK.The system menu appears.4. a. Under Configuration, click Slot.b. Move the mouse pointer over the installedVoIP Gateway Card to display the menu ofoptions.c. Click Port Property.
