3.3 Programming the VoIP Gateway Card in the Chicago OfficeGetting Started 373.3 Programming the VoIP Gateway Card in theChicago OfficeThis section details the procedure to programme the VoIP Gateway Card in the Chicago office, whichfor the most part is a duplication of that for the Los Angeles office. For general information that is notdiscussed here, refer to the relevant sections in "3.2 Programming the VoIP Gateway Card in the LosAngeles Office".There are differences in the procedure where distinct setting values are required for parameters thatare dependent on the specific network configuration of the Chicago office. Also, the addresstranslation table does not need to be programmed, because the one downloaded from the card in theLos Angeles office already contains the information for the entire network. You can simply upload theaddress translation table from the Los Angeles office, and the cards can communicate with eachother on the network.Starting the IP-GW16 Maintenance UtilityChanging the Status of the VoIP Gateway Card1. Start Internet Explorer from the Start menu.2. a. In the Address box of Internet Explorer, typehttp://192.168.1.200 (default IP address of thecard).Make sure that the PC has the appropriate IPaddress setting to access the card (refer to"3.1.1 Preparing the PC").b. Press the ENTER key on the keyboard.3. a. In the Username box, type Administrator(default user name).b. In the Password box, type Administrator(default password).c. Click LOGIN.The main menu appears.1. Click 2.1 Change RUN/STOP status in the mainmenu.2. a. Click STOP for Status after changing.b. Click OK.c. Click OK.d. Click OK.
