2.6 Utility2.6.1 Utility—DiagnosisPerforms diagnostic tests on cards installed in the PBX, to identify the source of problems.If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test results can besaved as a TXT-format (text) file.When testing is complete, any cards that were set to OUS status must be returned to INS status if they are tobe used again.Card TestTests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary accordingto the type of card being tested.The tests that are performed on each card are as follows:Test Type Available CardsLocal loop back diagnosis DHLC, DLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16,CSLC16, ECSLC24, CSIF, LCOT, ELCOT, T1, E1, BRI, PRI, OPB,E&M, DID, IP-EXTCard CT Bus diagnosis(KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200 only)DHLC, DLC, SLC8, SLC16, MSLC16, CSLC16, CSIF, LCOT, T1,E1, BRI, PRI, OPB, E&M, DID, IP-EXTDTMF Receive test port DHLC, SLC8, SLC16, MSLC16, ESLC16, EMSLC16, CSLC16,ECSLC24, E&M, DIDPT loop back diagnosis DHLC, DLCDSP DTMF generator/receiverdiagnosisT1, E1DSP DTMF receiver diagnosis T1, E1Framer IC alarm signal detectiondiagnosisT1, E1, PRIFramer IC error detection diagnosis T1, E1, PRICS-INF loop back diagnosis(KX-TDE series only)CSIFSuper frame synchronizationdiagnosis (KX-TDE series only)CSIFCaller ID card loop back diagnosis LCOT, ELCOTExtension mode setting test BRIIP-GW H.323 call simulatediagnosis (KX-TDE series only)IP-GW4, IP-GW16LAN loop back diagnosis (KX-TDEseries only)IP-GW464 PC Programming Manual2.6.1 Utility—Diagnosis
