Panasonic KX-NCP500 Programming Manual

Also see for KX-NCP1000: Brochure & specs Specifications Installation manual Guide Networking guide

Contents

Panasonic KX-NCP500 Programming Manual Manual pdf 845 page image

VM Trunk Group No.Specifies the number of the VM trunk group sent to the VPS when the DIL destination is the floating extensionnumber of a VM (DPT) Group.The VM trunk group number is used to allow the VPS to send the applicable greeting message to the caller.Default1Value Range1–48Maintenance Console Location12.2 [10-2] DIL Table & Port SettingsProgramming Manual ReferencesNoneFeature Manual References4.1.7 DIL (Direct In Line)19.1.4 Voice Mail DPT (Digital) IntegrationCLI for DILWhen CLI distribution is enabled for a CO line to which DIL distribution is set, incoming CO line calls will bedistributed to the CLI destinations (instead of the DIL destinations) if the caller’s identification number is foundin the System Speed Dialing Table.CLI distribution can be enabled or disabled for each time mode (day/lunch/break/night) on a CO line basis.ShelfIndicates the shelf type and/or position (reference only).DefaultCurrent shelf type/numberValue RangeFor KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200:Physical, VirtualFor KX-TDE600:Shelf number, VirtualMaintenance Console Location12.2 [10-2] DIL Table & Port SettingsProgramming Manual ReferencesNoneDocument Version 2011-10 PC Programming Manual 84512.2 [10-2] DIL Table & Port Settings