TroubleshootingVQT4E90 87The remote control does not work.• The remote control and main unit are usingdifferent codes. Change the code on the remotecontrol.• Software (firmware) is updating when “UPD/” is displaying on the unit’s display. Wait untilthe update is completed. (> 84)• The HOLD function is activated. (> 85)Startup is slow.• Startup takes time in the following situations:- A disc is inserted.- The clock is not set.- Immediately after a power failure or the ACmains lead is connected.- When a BD-J application is executing.- When the “Power Save in Standby” isactivated. (> 81)“0:00” is flashing on the unit’s display.• Set the clock. (> 70, 82)The clock does not display on the unit whenswitched to standby.• The clock does not display when “Unit’s Display”is set to “Automatic”. (> 78)Screen size is wrong.• Check the “TV Aspect” or “Aspect for 4:3 Video”.(> 78)• Adjust the aspect ratio setting on TV.• If you connect to 4:3 TV, set “HDMI VideoFormat” to “576p/480p”. (> 70, 79)The black screen appears on the TV.• This phenomenon may occur, depending on theTV setting, when “Power Save in Standby” is setto “Off”. Depending on the TV, this phenomenonmay be prevented by reconnecting to a differentHDMI input terminal.TV reception is not displayed.• Broadcast signals are not output from this unit’sRF OUT terminal. Select “On” in “RF OUT( Aerial Signal )”. (> 70, 82)Picture does not appear with the HD qualityalthough HD setting was made.• The pictures are output with 576p/480pdepending on the title.The screen changes automatically.• If “Screen Saver” is set to “On”, the screen saverfunction will be activated when there is nooperation for 5 minutes or more. (> 78)There is a lot of image lag when playing video.• Set “HD optimizer” in the Picture menu to “Off”.(> 69)• Set “Audio Delay”. (> 70, 77)Unit's displayPress and hold [OK] andthe indicated numberbutton at the same timefor more than 5 seconds.(> 82)DisplaysTV screen and video