Panasonic Diga DMR-PWT520 Operating Instructions Manual

Also see for Diga DMR-PWT420: Operating instructions

Contents

VQT4E9012Getting startedControl reference guide1 Standby/on switch (Í/I)Press to switch the unit from on to standbymode or vice versa. In standby mode, the unitis still consuming a small amount of power.2 Recording indicator• The indicator will light up while recording.• The indicator will blink while recording ispaused and before recording starts.3 [PWT520] CALL LED• The LED will light up when this unit receivesincoming call etc. of the videocommunication. (> 66)4 Remote control signal sensor• Angle: Approx. 20° up and down, 30° left andright• Distance: Within approx. 7 m in front of theunit5 Open/close disc tray6 Disc tray7 USB port8 SD card slot• When removing the SD card, press on thecentre of the card and pull it straight out.9 Stop: Start play; Display1 Drive (HDD, BD or SD) indicator2 Disc indicator3 Copying indicator4 USB port indicator5 SD card slot indicator6 Remote control signal indicator7 Timer recording indicator• This indicator lights up when the timerrecording standby is activated.8 Main display section indicator- Current time- Playback counter- Various messages (> 92)9 Playback indicator• While writing to/reading from the media, do not switch theunit to standby mode or remove the media. Such actionmay result in loss of the media contents.• When inserting the media, ensure that it is facing the rightway up.Main unit PWT520Pull to flip downthe front panel.SD cardUSB memoryPress [< OPEN/CLOSE] to open thetray and insert or remove a disc.PLAYCOPY SDUSBHDDSDBD1 2 5 76438 9