187DX-600/800APR 2002Edition 1.05.1.7. Service Mode 7 (LBP Service Mode)This Service Mode is used to change printer parameters and verify printer information.Use the following procedure to change printer parameter.Service Mode 7Step Operation or Unit Condition LCD Display1 Standby2 Press “FUNCTION” and then “7”.3 Press “MONITOR” four times, then press “*”.4 Press “7”.5 1) Press "START" for printer parameter settings.Press "2" and "START" to get the printer information.Ex: Enter "START" for printer parameter settings.6 Press "3" and “START”.Then enter the number of pages.Ex: Enter "50" and press "START".7 Press "\/" or "/\" to select another Parameter Name(See Table) or press "CLEAR" to return to step 4.8 Repeat step 5 through 7 to request operation, or press"STOP" twice to return to standby.Sub-Code Parameter Name Description11 PRINTER COUNTER Displays and resets the Printer and PaperCassette(s) counters.2 LBP FUSER RESET Clears the LBP Fuser Error.3 OUT OF TONER Sets the number of pages to print after low toneris detected. (Factory default = 100, adjustablefrom 0 - 999)2\/ /\ PRINT AVAILABLE Shows the remaining number of allowableprintable pages after low toner has beendetected (Counter Only).\/ /\ LBP MEMORY CAPACITY Shows the Page Memory Capacity.MMM-dd-yyyy 15:0000%SET MODE (1-8)ENTER NO. ORSERVICE MODEENTER NO. OR1:LBP PARAMETER SETLP SERVICE MODE (1-2)1.PRINTER COUNTERLBP PARAMETER SET3.OUT OF TONERLBP PARAMETER SET1.LBP PARAMETER SETLP SERVICE MODE (1-2)MMM-dd-yyyy 15:0000%
