6RQT8792Preparations1 Attaching the battery (When the unit is off)The illustrations shown are of CGR-H711; however the steps for CGR-H712 (optional) orCGR-H701 (optional) are the same.Detaching≥ Turn the unit off before detaching the battery pack.When not using for long periods of time≥ Remove the battery pack (➜ left).(Even when the unit is turned off, there is asmall amount of voltage running through theunit, and this may result in a malfunction.)≥ Recharge the battery for re-use.RELEASEDETACH ATTACHClicks into placeCheck to make sure it is securely fastened.Bottom side of this unitRELEASEDETACH ATTACHBattery packRELEASEDETACH ATTACH1 Press and hold2 DC INDC IN 12 V To householdmains socketAC adaptor(included)AC mains lead (included)≥ You can also use this unit without charging whileconnecting the AC adaptor and the AC mains lead.≥ You can also use this unit without charging whileconnecting Car DC Adaptor (➜ page 24, Enjoying in a car).To conserve powerThis unit consumes 0.4 W of power even when turnedoff. When the unit is not going to be used for a long time,disconnect the AC mains lead from the household mainssocket.The unit is in the standby condition (the [Í] indicatorlights) when the AC mains lead is connected. Theprimary circuit is always “live” as long as the AC adaptoris connected to an electrical outlet.2 Recharging the batteryThe battery is not charged at the time of purchase. Charge before initial use.[Í] goes out ➜ lights§[CHG] lights ➜ goes out§ Only when recharged with the unitoff.Recharging time :➜ page 7, Approximate rechargingand play timesWhen finished, disconnect the ACadaptor and the AC mains lead .ÍCHGStarted FinishedPreparations