Section 400-Programming Appendix D. CPC-AII/B 8.0 Feature UpdateDBS-2.3/9.2-400 DBS Manual - Revised April 2000 Page D-9• Or, to exit the directory without selecting a number to dial,press the END key or go on-hook.Notes Available on small-display phones only. This feature applies to the 44-Series small-display phone only (i.e., phones with a 2-line LCD display).Incompatibility with older phone versions. Directory Mode is availableon the 44-Series phones only.Hot Dial Pad and Directory Mode. The Hot Dial Pad feature (FF3ExtPort# 48#) will not work on an extension in Directory Mode.Variable Mode44-Series phones onlyCPC-AII/B Version 8.0, CPC-S/M Version 2.0, or CPC-EX Version 1.0 onlyDescription This feature applies to the 44-Series small-display phone only (i.e., phoneswith a 2-line LCD display).When the phone is in Variable Mode, the features for Flexible FunctionScreen select keys 1 and 2 will display during each of the following callstates:Call State Existing Program Address*• During an intercom call FF3 (ExtPort)# 28# (25-39)#• During CO dial tone FF3 (ExtPort)# 29# (25-39)#• During a trunk call FF3 (ExtPort)# 30# (25-39)#• After dialing a busy extension FF3 (ExtPort)# 33# (25-39)#* In these addresses, you assign a Flexible Function Screen (25-39) toappear on the extension while it is in the call state.Operation The select keys on the 44-Series small-display phone are labeled “>” and“<“to the left and right of the display’s 2nd line. Pressing select key 1 (“>”on the left) or select key 2 (“<“on the right) will perform the displayedfeature.To use Variable Mode:1. Activate Variable Mode by pressing ON/OFF *61 ON/OFF.• When you dial *61 in the above sequence, the 1st line of theLCD will display “Variable md ON”. The display willreturn to normal when you press the second ON/OFF.• Use existing addresses FF1 2# 7# 2# to assign screen text.
