Panasonic CY-VMC7000U Operating Instructions Manual

Also see for CY-VMC7000U: Operating manual

Panasonic CY-VMC7000U Operating Instructions Manual Manual pdf 39 page image

!6 Power ConnectorGround LeadTo a clean, bare metallicpart of the car chassisBattery LeadTo the car battery,continuous +12V DCVideo Control LeadTo the Video Control lead ofthe Panasonic car navigationsystem (not available yet)Power LeadTo ACC power, +12V DC(Green / yellow stripe)(Fuse 5A)(Yellow)(Red)(Black)(Bule / yellow stripe)(Violet / white stripe)(Resistor 220Ω)Reverse LeadWhen connecting the rearview camera, use the reverselead. (a page 47)Side Brake (Parking Brake)Connection LeadBe sure to wire the parkingbrake for safety and preventingaccidents. (a page 46) (Black)(Black)(Black / green stripe)Speaker LeadPre-out Cord(R) (Red)(L) (White)RGB Input CordTo the RGB Connector of the Panasoniccar navigation system (not available yet)!9 Display Unit / Control Unit Connecting CordCY-VMC7000UDisplay Unit (Rear)Use a Reverse Extension Cord!7 if needed.!@42 CY-VMC7000U33ENGLISHElectrical ConnectionsCautions:¡This product is designed to operate off a 12 volt, negative ground battery system.¡To prevent damage to the unit, be sure to follow the connection diagram below.¡Remove approx. 1/4" (5mm) of protective covering from the ends of the leads before connecting.¡Do not insert the power connector into the unit until the wiring is completed.¡Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables and keepcable terminals free from touching any metal parts.¡Remember, if your car has a drive computer or a navigation computer, the data of its memory may be erased whenthe battery terminals are disconnected.Wiring DiagramNo. Item Q'ty!6 Power Connector 1Supplied Hardware!7 Reverse ExtensionCord 1!8 Clip Connector 1!9 Display Unit / ControlUnit Connecting Cord 1