Panasonic CY-VMC7000U Operating Instructions Manual

Also see for CY-VMC7000U: Operating manual

Panasonic CY-VMC7000U Operating Instructions Manual Manual pdf 33 page image

36 CY-VMC7000U27ENGLISHInstallation Guide (continued)Power LeadIf your car has a radio or is pre-wired for one :Cut the connector wires one at a time from the plug(leaving the leads as long as possible) so that youcan work with individual leads. Turn the ignition onto the accessory position, and ground one lead ofthe test bulb to the chassis.Touch the other lead of the test bulb to each of theexposed wires from the cut radio connector plug.Touch one wire at a time until you find the outlet thatcauses the test bulb to light.Now turn the ignition off and then on. If the bulb alsoturns off and on, that outlet is the car power lead.If your car is not wired for an audio unit :Go to the fuse block and find the fuse port foraccessory (ACC) or ignition (IGN).Battery LeadIf your stereo unit has a yellow lead, you will need tolocate the car's battery lead. Otherwise you mayignore this procedure. (The yellow battery lead pro-vides continuous power to maintain a clock, memorystorage, or other functions.)If your car has a radio or is pre-wired for one:With the ignition and headlights off, identify the carbattery lead by grounding one lead of the test bulbto the chassis and checking the remaining exposedwires from the cut radio connector plug.If your car is not wired for an audio unit :Go to the fuse block and find the fuse port for thebattery, usually marked BAT.❏ Connect All LeadsNow that you have identified all the wires in the car,you're ready to begin connecting them to the LCDmonitor wires. The connection diagram (B page42) shows the proper connections and color codingof the leads.We strongly recommend that you test the unitbefore making a final installation.You can set the unit on the floor and make tempo-rary connections to test the unit. Use electrical tapeto cover all exposed wires.Important: Connect the red power lead last, afteryou have made and insulated all other connections.GroundConnect the black ground lead of the power connec-tor to the metal car chassis.BatteryConnect the yellow battery lead to the correct radiowire or to the battery fuse port on the fuse block.EquipmentConnect any optional equipment such as an DVDvideo player according to the instructions furnishedwith the equipment. Read the operating and installa-tion instructions of any equipment you will connectto this unit.PowerConnect the red power lead to the correct car radiowire or to the appropriate fuse port on the fuseblock.If the LCD monitor functions properly with all theseconnections made, disconnect the wires and pro-ceed to the final installation.❏ Final InstallationLead ConnectionsConnect all wires, making sure that each connectionis insulated and secure. Bundle all loose wires andfasten them with tape so they won't fall down later.Now insert the LCD monitor into the mounting collar.Congratulations! After making a few final checks,you’re ready to enjoy your new LCD monitor.❏ Final Checks1. Make sure that all wires are properly connect-ed and insulated.2. Make sure that the LCD monitor is securelyheld in the mounting collar.3. Turn on the ignition to check the unit for prop-er operation.If you have difficulties, consult your nearest autho-rized professional installer for assistance.